On Wed, Jun 20, 2018 at 8:52 AM, Robert Jarzmik <robert.jarzmik@xxxxxxx> wrote:
> Rob Herring <robh+dt@xxxxxxxxxx> writes:
>
>> Like PCI, USB, SDIO, etc., you need to define an AC97 bus binding
>> which defines child node structure, compatible formatting (if you can
>> base compatibles on something like VID/PID), and addressing (reg and
>> unit-address formats). Then once you define child nodes, you can add
>> whatever sideband connections you need. The AC97 core should be able
>> to populate struct device_node if there are any matching child
>> devices.
> Ok, I thing I understand.
>
> So the device-tree will look like :
> ac97: sound@40500000 {
> compatible = "marvell,pxa270-ac97";
> reg = < 0x40500000 0x1000 >;
> interrupts = <14>;
> reset-gpios = <&gpio 95 GPIO_ACTIVE_HIGH>;
> #sound-dai-cells = <1>;
> pinctrl-names = "default";
> pinctrl-0 = < &pinctrl_ac97_default >;
> clocks = <&clks CLK_AC97>, <&clks CLK_AC97CONF>;
> clock-names = "AC97CLK", "AC97CONFCLK";
>
> wm9713@0 {
audio-codec@0
> reg = <0>; /* Codex index (between 0 and 3) */
> compatible = "ac97-codec";
This should be something with 'wm9713' in it or if there are ID
registers you can base it on that.
> clocks = <&fixed_wm9713_clock>;
> clock-names = "ac97_clk";
This is the standard 12MHz clock?
> }
> };
>
> And the function ac97_codec_add() will :
> - scan the device-tree ac97 controller childs
> - match one if its reg equals (in our case wm9713@0)
> - set codec->dev.of_node to the matched one
Not familiar with that function, but that sounds about right.
Rob
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
