On Thu, Apr 26, 2018 at 5:16 AM Vijendar Mukunda <Vijendar.Mukunda@xxxxxxx>
wrote:
Added sram bank variable to audio_substream_data structure.
Signed-off-by: Vijendar Mukunda <Vijendar.Mukunda@xxxxxxx>
Move initialization to acp_dma_open(), otherwise this is:
Reviewed-by: Daniel Kurtz <djkurtz@xxxxxxxxxxxx>
---
sound/soc/amd/acp-pcm-dma.c | 20 +++++---------------
sound/soc/amd/acp.h | 20 ++++++++++++++------
2 files changed, 19 insertions(+), 21 deletions(-)
diff --git a/sound/soc/amd/acp-pcm-dma.c b/sound/soc/amd/acp-pcm-dma.c
index cb22653..b7bffc7 100644
--- a/sound/soc/amd/acp-pcm-dma.c
+++ b/sound/soc/amd/acp-pcm-dma.c
@@ -320,29 +320,16 @@ static void config_acp_dma(void __iomem *acp_mmio,
struct audio_substream_data *rtd,
u32 asic_type)
{
- u32 sram_bank;
-
- if (rtd->direction == SNDRV_PCM_STREAM_PLAYBACK)
- sram_bank = ACP_SHARED_RAM_BANK_1_ADDRESS;
- else {
- switch (asic_type) {
- case CHIP_STONEY:
- sram_bank = ACP_SHARED_RAM_BANK_3_ADDRESS;
- break;
- default:
- sram_bank = ACP_SHARED_RAM_BANK_5_ADDRESS;
- }
- }
acp_pte_config(acp_mmio, rtd->pg, rtd->num_of_pages,
rtd->pte_offset);
/* Configure System memory <-> ACP SRAM DMA descriptors */
set_acp_sysmem_dma_descriptors(acp_mmio, rtd->size,
rtd->direction, rtd->pte_offset,
- rtd->ch1, sram_bank,
+ rtd->ch1, rtd->sram_bank,
rtd->dma_dscr_idx_1, asic_type);
/* Configure ACP SRAM <-> I2S DMA descriptors */
set_acp_to_i2s_dma_descriptors(acp_mmio, rtd->size,
- rtd->direction, sram_bank,
+ rtd->direction, rtd->sram_bank,
rtd->destination, rtd->ch2,
rtd->dma_dscr_idx_2, asic_type);
}
@@ -795,6 +782,7 @@ static int acp_dma_hw_params(struct snd_pcm_substream
*substream,
}
rtd->ch1 = SYSRAM_TO_ACP_CH_NUM;
rtd->ch2 = ACP_TO_I2S_DMA_CH_NUM;
+ rtd->sram_bank = ACP_SRAM_BANK_1_ADDRESS;
rtd->destination = TO_ACP_I2S_1;
rtd->dma_dscr_idx_1 = PLAYBACK_START_DMA_DESCR_CH12;
rtd->dma_dscr_idx_2 = PLAYBACK_START_DMA_DESCR_CH13;
@@ -805,9 +793,11 @@ static int acp_dma_hw_params(struct
snd_pcm_substream *substream,
switch (adata->asic_type) {
case CHIP_STONEY:
rtd->pte_offset = ACP_ST_CAPTURE_PTE_OFFSET;
+ rtd->sram_bank = ACP_SRAM_BANK_2_ADDRESS;
break;
default:
rtd->pte_offset = ACP_CAPTURE_PTE_OFFSET;
+ rtd->sram_bank = ACP_SRAM_BANK_5_ADDRESS;
}
rtd->ch1 = SYSRAM_TO_ACP_CH_NUM;
rtd->ch2 = ACP_TO_I2S_DMA_CH_NUM;
diff --git a/sound/soc/amd/acp.h b/sound/soc/amd/acp.h
index 2f48d1d..62695ed 100644
--- a/sound/soc/amd/acp.h
+++ b/sound/soc/amd/acp.h
@@ -19,12 +19,19 @@
#define ACP_PHYSICAL_BASE 0x14000
-/* Playback SRAM address (as a destination in dma descriptor) */
-#define ACP_SHARED_RAM_BANK_1_ADDRESS 0x4002000
-
-/* Capture SRAM address (as a source in dma descriptor) */
-#define ACP_SHARED_RAM_BANK_5_ADDRESS 0x400A000
-#define ACP_SHARED_RAM_BANK_3_ADDRESS 0x4006000
+/*
+ * In case of I2S SP controller instance, Stoney uses SRAM bank 1 for
+ * playback and SRAM Bank 2 for capture where as in case of BT I2S
+ * Instance, Stoney uses SRAM Bank 3 for playback & SRAM Bank 4 will
+ * be used for capture. Carrizo uses I2S SP controller instance. SRAM
Banks
+ * 1, 2, 3, 4 will be used for playback & SRAM Banks 5, 6, 7, 8 will be
used
+ * for capture scenario.
+ */
+#define ACP_SRAM_BANK_1_ADDRESS 0x4002000
+#define ACP_SRAM_BANK_2_ADDRESS 0x4004000
+#define ACP_SRAM_BANK_3_ADDRESS 0x4006000
+#define ACP_SRAM_BANK_4_ADDRESS 0x4008000
+#define ACP_SRAM_BANK_5_ADDRESS 0x400A000
#define ACP_DMA_RESET_TIME 10000
#define ACP_CLOCK_EN_TIME_OUT_VALUE 0x000000FF
@@ -95,6 +102,7 @@ struct audio_substream_data {
u16 dma_dscr_idx_1;
u16 dma_dscr_idx_2;
u32 pte_offset;
+ u32 sram_bank;
u32 byte_cnt_high_reg_offset;
u32 byte_cnt_low_reg_offset;
uint64_t size;
--
2.7.4
