I'm having an issue with a codec where the normal DAPM procedure of disabling most of the codec when there is no stream ongoing results in large clicks when a playback stream starts and stops, because the output jumps from 0V when the output is disabled to over a volt when the output is enabled. There appears to be a 'slow stop/start' feature in the codec, however, it takes about one second to ramp up and down the output voltage, and that is too long a delay when starting a stream. In our usecase the power consumtion of the codec is negligable compared to the rest of the electronics, so leaving the codec running at all times is perfectly feasible. Is there any way from a machine driver to disable the DAPM switching, i.e. leave parts of the codec running at all times? In this specific case, there are two internal PM controls which enable the output. One of them is controlled by an output mixer element (SND_SOC_DAPM_MIXER_E), and the other one from set_bias_level(). I've had a look in the core code, but it seems that the whole business of changing the bias level when a stream is started is always performed and that there is no way to say "Set the bias level to ON and leave it there". An alternative would be to augment the codec driver with an 'always on' feature, which effectively always enables PM for certain parts of the chip. But it seems like the wrong place to do this type of thing. Another use for this feature is that we have had a lot of problems over the years with buggy I2S interfaces misbehaving when streams are started and stopped, and there would be an advantage to letting the AIF run the whole time after startup. /Ricard -- Ricard Wolf Wanderlöf ricardw(at)axis.com Axis Communications AB, Lund, Sweden www.axis.com Phone +46 46 272 2016 Fax +46 46 13 61 30 _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
