Hi, On Thu, Aug 10, 2017 at 11:02:34AM +0100, Srinivas Kandagatla wrote: > Hi Damien, > Thanks for testing. > > On 09/08/17 22:10, Damien Riegel wrote: > > Hi Srinivas, > > > > On Wed, Aug 09, 2017 at 06:49:25PM +0200, srinivas.kandagatla@xxxxxxxxxx wrote: > > > From: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx> > > > > > > MBHC (MultiButton Headset Control) support is available in pm8921 in two > > > blocks, one to detect mechanical headset insertion and removal and other > > > block to support headset type detection and 5 button detection and othe > > > features like impedance calculation. > > > > > > This patch adds support to: > > > 1> Support to NC and NO type of headset Jacks. > > > 2> Mechanical insertion and detection of headset jack. > > > 3> Detect a 3 pole Headphone and a 4 pole Headset. > > > 4> Detect 5 buttons. > > > > > > Tested it on DB410c with Audio Mezz board with 4 pole and 3 pole > > > headset/headphones. > > > > I have the same issue with this patchset, KEY_MEDIA is being reported > > when unplugging a headset. I added a few traces and what I observe is > Am unable to reproduce the same issue, I tried atleast 6 different mix of > headset/headphones. > here is my evtest log: http://paste.ubuntu.com/25282592/ > > Could you explain bit more about your setup, so that I can try to reproduce > the same issue. > > My setup is DB410c + Audio Mezz board > https://www.arrow.com/en/products/audiomezz/seeed-technology-limited I'm using a hardware based on Intrinsyc Open-Q 410 Development Kit: https://www.intrinsyc.com/snapdragon-embedded-development-kits/snapdragon-410-development-kit/ We use the same SoM with a different carrier board, but connections to the jack connector are routed the same way on both carrier boards. > > that the "button pressed" irq is fired when unplugging, but no "button > > released" irq follows. To get a "button released" irq, I need to either > > plug a headset, or plug-and-unplug headphones. > > > > So basically, detection fails because we don't get the "button pressed" > > irq prior to the mechanical switch irq. Do you know what could explain > > the MBHC not firing the "button released" irq when unplugging headset? > > > Can you also share output of evetest and /proc/interrupts so that i can see > if the extra logic of masking btn0 is creating the issue, we can also try > removing the btn0 accessory detect logic and see if we get correct button > press/releases. It's definitely what's causing the headphones to be reported as headset, but not what's causing the interrupt not to be triggered in the first place. I don't have access to the hardware right now, so I'll provide you with logs next week. Thanks, -- Damien _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
