On Fri, Jun 2, 2017 at 5:03 PM, Richard Fitzgerald <rf@xxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote: > These codecs have a variable number of I/O lines each of which > is individually selectable to a wide range of possible functions. > > The functionality is slightly different from the traditional muxed > GPIO since most of the functions can be mapped to any pin (and even > the same function to multiple pins). Most pins have a dedicated > "alternate" function that is only available on that pin. The > alternate functions are usually a group of signals, though it is > not always necessary to enable the full group, depending on the > alternate function and how it is to be used. The mapping between > alternate functions and GPIO pins varies between codecs depending > on the number of alternate functions and available pins. > > Note on the Kconfig options: > The formula "default y if..." is used for PINCTRL_MADERA so that its > select options will be processed, allowing us to group selects for > pinctrl into the pinctrl Kconfig where they logically belong instead > of accumulating under the parent MFD Kconfig. > > Signed-off-by: Richard Fitzgerald <rf@xxxxxxxxxxxxxxxxxxxxxxxxxxx> > --- > Changes since V2: > - Removed unused drive strength settings to tidy the code > - Use devm_pinctrl_register_and_init() to avoid the problems with > pinctrl_register() > - Replaced a couple of hardcoded masks with the defined constant There is a Kconfig problem as pointed out by the build robot. Apart from that this looks like merge material, and we need to think about a merge strategy like with the GPIO patch, once the MFD portions are ready. Yours, Linus Walleij _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
