Hi Marek, On 19.09.2016 21:30, Marek Vasut wrote: > Same as commit ce492b3b8f99cf9d2f807ec22d8805c996a09503 > Subject: drm/fsl-dcu: use flat regmap cache > > Using flat regmap cache instead of RB-tree to avoid the following > lockdep warning on driver load: > WARNING: CPU: 0 PID: 1 at kernel/locking/lockdep.c:2871 lockdep_trace_alloc+0x104/0x128 > DEBUG_LOCKS_WARN_ON(irqs_disabled_flags(flags)) > > The RB-tree regmap cache needs to allocate new space on first > writes. That's why SSI driver had .num_reg_defaults_raw set in regmap config. With this set and .reg_defaults_raw unset regcache_hw_init() will read existing register content which then will be used to populate cache (and so allocate RB tree nodes) at regcache initialization time. This means that allocation of new cache RB tree nodes should never happen during actual write. If you get a warning that it happened then maybe there is a write to some register not covered by .num_reg_defaults_raw - this should be fixed. The problem with flat cache is that it is zero-initialized, that is, all registers are assumed to contain zeros by default. This is generally not true in case of SSI so reads from and bit updates in non-volatile registers will corrupt their value. You can also refer to discussion when .num_reg_defaults_raw was first added here: http://www.gossamer-threads.com/lists/linux/kernel/2330573 Maciej _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
