The codec chip has a physical MUTE pin to let users control it via
GPIO. So this patch add a mute control support to the driver.
Signed-off-by: Nicolin Chen <nicoleotsuka@xxxxxxxxx>
---
Changelog:
v1->v2
* Revise the DT binding part regarding the active state of the mute pin
.../devicetree/bindings/sound/cs53l30.txt | 4 +++
sound/soc/codecs/cs53l30.c | 30 ++++++++++++++++++++++
sound/soc/codecs/cs53l30.h | 1 +
3 files changed, 35 insertions(+)
diff --git a/Documentation/devicetree/bindings/sound/cs53l30.txt b/Documentation/devicetree/bindings/sound/cs53l30.txt
index 18d6b99..4dbfb82 100644
--- a/Documentation/devicetree/bindings/sound/cs53l30.txt
+++ b/Documentation/devicetree/bindings/sound/cs53l30.txt
@@ -13,6 +13,10 @@ Optional properties:
- reset-gpios : a GPIO spec for the reset pin.
+ - mute-gpios : a GPIO spec for the MUTE pin. The active state can be either
+ GPIO_ACTIVE_HIGH or GPIO_ACTIVE_LOW, which would be handled
+ by the driver automatically.
+
- cirrus,micbias-lvl : Set the output voltage level on the MICBIAS Pin.
0 = Hi-Z
1 = 1.80 V
diff --git a/sound/soc/codecs/cs53l30.c b/sound/soc/codecs/cs53l30.c
index 384a3f7..e46b7de 100644
--- a/sound/soc/codecs/cs53l30.c
+++ b/sound/soc/codecs/cs53l30.c
@@ -35,6 +35,7 @@ struct cs53l30_private {
struct regulator_bulk_data supplies[CS53L30_NUM_SUPPLIES];
struct regmap *regmap;
struct gpio_desc *reset_gpio;
+ struct gpio_desc *mute_gpio;
struct clk *mclk;
bool use_sdout2;
u32 mclk_rate;
@@ -833,6 +834,16 @@ static int cs53l30_set_dai_tdm_slot(struct snd_soc_dai *dai,
return 0;
}
+static int cs53l30_mute_stream(struct snd_soc_dai *dai, int mute, int stream)
+{
+ struct cs53l30_private *priv = snd_soc_codec_get_drvdata(dai->codec);
+
+ if (priv->mute_gpio)
+ gpiod_set_value_cansleep(priv->mute_gpio, mute);
+
+ return 0;
+}
+
/* SNDRV_PCM_RATE_KNOT -> 12000, 24000 Hz, limit with constraint list */
#define CS53L30_RATES (SNDRV_PCM_RATE_8000_48000 | SNDRV_PCM_RATE_KNOT)
@@ -846,6 +857,7 @@ static const struct snd_soc_dai_ops cs53l30_ops = {
.set_sysclk = cs53l30_set_sysclk,
.set_tristate = cs53l30_set_tristate,
.set_tdm_slot = cs53l30_set_dai_tdm_slot,
+ .mute_stream = cs53l30_mute_stream,
};
static struct snd_soc_dai_driver cs53l30_dai = {
@@ -990,6 +1002,24 @@ static int cs53l30_i2c_probe(struct i2c_client *client,
cs53l30->mclk = NULL;
}
+ /* Fetch the MUTE control */
+ cs53l30->mute_gpio = devm_gpiod_get_optional(dev, "mute",
+ GPIOD_OUT_HIGH);
+ if (IS_ERR(cs53l30->mute_gpio)) {
+ ret = PTR_ERR(cs53l30->mute_gpio);
+ goto error;
+ }
+
+ if (cs53l30->mute_gpio) {
+ /* Enable MUTE controls via MUTE pin */
+ regmap_write(cs53l30->regmap, CS53L30_MUTEP_CTL1,
+ CS53L30_MUTEP_CTL1_MUTEALL);
+ /* Flip the polarity of MUTE pin */
+ if (gpiod_is_active_low(cs53l30->mute_gpio))
+ regmap_update_bits(cs53l30->regmap, CS53L30_MUTEP_CTL2,
+ CS53L30_MUTE_PIN_POLARITY, 0);
+ }
+
if (!of_property_read_u8(np, "cirrus,micbias-lvl", &val))
regmap_update_bits(cs53l30->regmap, CS53L30_MICBIAS_CTL,
CS53L30_MIC_BIAS_CTRL_MASK, val);
diff --git a/sound/soc/codecs/cs53l30.h b/sound/soc/codecs/cs53l30.h
index 0dd4afb..5e39da5 100644
--- a/sound/soc/codecs/cs53l30.h
+++ b/sound/soc/codecs/cs53l30.h
@@ -253,6 +253,7 @@
#define CS53L30_MUTE_MB_ALL_PDN_MASK (1 << CS53L30_MUTE_MB_ALL_PDN_SHIFT)
#define CS53L30_MUTE_MB_ALL_PDN (1 << CS53L30_MUTE_MB_ALL_PDN_SHIFT)
+#define CS53L30_MUTEP_CTL1_MUTEALL (0xdf)
#define CS53L30_MUTEP_CTL1_DEFAULT (0)
/* R32 (0x20) CS53L30_MUTEP_CTL2 - MUTE Pin Control 2 */
--
2.1.4
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
