On 06/13/2016 05:14 PM, Mark Brown wrote: > On Mon, Jun 13, 2016 at 12:52:37PM +0200, Sylwester Nawrocki wrote: > >> [s.nawrocki: removed unused macro definitions and regulator handling >> code, rewrote regmap config code, added support for speaker enable >> and global chip enable through DAPM, rewritten as component driver, >> redesigned DT bindings] > > Removed the regulator handling code? Why? Because it was effectively a dead code (disabled by a DT flag property) and didn't make any sense on our test board. It was setting regulator's load and voltage on a shared fixed voltage regulator. Even if calls like regulator_set_optimum_mode() were added that wouldn't make any difference, since the corresponding PMIC driver ops were not implemented. I started more or less with something like this [1]. >> + default: >> + /* Analog input, disable PCM, PDM Rx */ >> + regmap_write(map, MAX98504_REG_PCM_RX_ENABLE, 0); >> + regmap_write(map, MAX98504_REG_PDM_RX_ENABLE, 0); >> + } > > Add a break here please, at least for consistency. > >> + ret = PTR_ERR(max98504->regmap); >> + dev_err(&client->dev, "regmap initialization failed: %d\n", ret); >> + return ret; >> + } >> + >> + ret = max98504_probe(max98504); >> + if (ret < 0) >> + return ret; > > Why not just inline this code? Will do in next iteration. Thanks for your review. [1] https://github.com/halaszk/Perseus-halaszk-universal5433/blob/perseus5433-mm/sound/soc/codecs/max98504a.c _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
