From: "Lu, Han" <han.lu@xxxxxxxxx>
Add noise detection for alsabat.
Alsabat reports error when noise above threshold be detected.
Use either of the options below to designate the threshold. (e.g.
if the ratio of noise to signal is 5%, the snr is about 26dB.)
--snr-db <value in dB>
--snr-pc <value in %>
The noise detection is performed in time domain. On each period
of the sine wave being analyzed, alsabat substracts a clean sine
wave from the source, calculates the RMS value of the residual,
and compares the result with the threshold. At last, alsabat
returns the number of periods with noise above threshold. 0 is
returned when the source is clean.
patch content:
1. align the data type and process on float
2. add a parameter for adjust_waveform()
3. add a single channel sine wave generator
4. add noise detection
Lu, Han (4):
alsabat: align the data type on float
alsabat: add channels parameter for adjust_waveform()
alsabat: add a single channel sine wave generator
alsabat: add noise detection
bat/alsabat-test.sh | 4 +
bat/alsabat.1 | 8 ++
bat/analyze.c | 216 +++++++++++++++++++++++++++++++++++++++++++++++-----
bat/bat-signal.h | 1 +
bat/bat.c | 62 ++++++++++++---
bat/common.h | 36 ++++++++-
bat/convert.c | 8 +-
bat/convert.h | 8 +-
bat/signal.c | 27 ++++++-
configure.ac | 2 +-
10 files changed, 327 insertions(+), 45 deletions(-)
--
2.5.0
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
