Hi Clemens, On Sun, Jun 5, 2016 at 8:16 PM, Clemens Gruber <clemens.gruber@xxxxxxxxxxxx> wrote: > I looked into this today and discovered the following: > > With my patch applied, if I reset the board just after playback, at the > next boot, the sgtl5000_fill_defaults function does not succeed: Writing > the default value 0x7060 to register 0x30 (CHIP_ANA_POWER) fails. > > How did CHIP_ANA_POWER change with my patch: Before, only > LINREG_SIMPLE_POWERUP was cleared as is recommended in the datasheet > when using the internal LDO, now both LINREG_SIMPLE_POWERUP and > STARTUP_POWERUP are cleared, as is recommended when using external VDDD. > > But why does the SGTL5000 nack that default write to CHIP_ANA_POWER > after a reboot, which interrupted the playback? > > The following patch from Eric solved the problem; one write fails but it > continues setting the other registers and thus even if resetting a board > during playback, the sound still works after reboot: > http://mailman.alsa-project.org/pipermail/alsa-devel/2015-February/088356.html > Another workaround might be to not even write a default value to > CHIP_ANA_POWER, as in this patch from Eric: > http://mailman.alsa-project.org/pipermail/alsa-devel/2015-February/088355.html > > What do you think we should do? Shouldn't both patches be applied? _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
