The debug logging of FLL calculations was confusing. Values were printed in hex without indicating this by a leading 0x, and despite these normally being required in decimal. Also where the register value isn't the actual value (it s a power-of-two or 0 means 1, 1 means 2, ...) it was unclear whether the actual or register value was shown. This patch changes the log print so that all mathematical values are shown in decimal, all register values are shown in hex with a 0x prefix, and where the register value isn't the actual integer value the decimal integer value is shown in () after the hex register value. Signed-off-by: Richard Fitzgerald <rf@xxxxxxxxxxxxxxxxxxxxxxxxxxx> --- sound/soc/codecs/arizona.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/sound/soc/codecs/arizona.c b/sound/soc/codecs/arizona.c index 913cfa8..92d22a0 100644 --- a/sound/soc/codecs/arizona.c +++ b/sound/soc/codecs/arizona.c @@ -2149,11 +2149,12 @@ static int arizona_calc_fll(struct arizona_fll *fll, return -EINVAL; } - arizona_fll_dbg(fll, "N=%x THETA=%x LAMBDA=%x\n", + arizona_fll_dbg(fll, "N=%d THETA=%d LAMBDA=%d\n", cfg->n, cfg->theta, cfg->lambda); - arizona_fll_dbg(fll, "FRATIO=%x(%d) OUTDIV=%x REFCLK_DIV=%x\n", - cfg->fratio, cfg->fratio, cfg->outdiv, cfg->refdiv); - arizona_fll_dbg(fll, "GAIN=%d\n", cfg->gain); + arizona_fll_dbg(fll, "FRATIO=0x%x(%d) OUTDIV=%d REFCLK_DIV=0x%x(%d)\n", + cfg->fratio, ratio, cfg->outdiv, + cfg->refdiv, 1 << cfg->refdiv); + arizona_fll_dbg(fll, "GAIN=0x%x(%d)\n", cfg->gain, 1 << cfg->gain); return 0; -- 1.9.1 _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
