Hi,
I've been developing a soundcard driver for an embedded picozed bearing
carrier card with 4 Cirrus CS42448 codecs. Each codec has 6 ADCs and 8
DACs, and is used in TDM mode, meaning there are 8 channel time slots on
both the input and output serial audio data lines (DAIs). Wired to
connectors (and so accessible to me) are all 6 analog inputs and 1
analog output, for each codec.
Each codec and its DAI link come up as a separate device. I used the
devices hw:2,n where n is the codec number. (hw:0 and hw:1 are the
dummy and loopback devices)
For each device/codec/DAI link, everything is as expected when using
arecord and aplay when I either pipe the arecord output to aplay, or
when arecord writes to WAV file and aplay outputs it. That is, an
analog signal applied to input channel 1 then appears on the output
channel (1) for the same codec.
The first weird thing is when I use speaker-test. If there were only 1
device/codec/DAI link I wouldn't notice anything odd. As expected only
1 channel shows a signal because only channel 0 is wired to a
connector. But with 4 codecs, when I output via codec n, the output I
see is on the channel that speaker-test thinks is channel n (ie. same
number as the codec), not channel 0, which it should be! Is this a
possible channel mapping bug in speaker-test?
The second weird thing is when I apply a signal to 1 channel at a time,
producing 24 WAV files output from arecord (4 codecs x 6 channels, but
each contains only 8 channels of data - 6 inputs for a given codec and 2
dummy channels). I copied the files to my desktop, played them through
vlc (as 7.1 surround) and used the PulseAudio Volume Meter to see which
channels have signal on it. Note that these files behaved completely as
expected when played through aplay on the embedded system. The result
was that the output channels were all over the place, seemingly random
with no apparent pattern. For some files the signals appeared on more
than 1 channel.
It appears that vlc or PulseAudio Volume Meter must do some kind of
remapping. What I don't get is that the WAV files only have 8 channels,
from a single codec, and should be independent of which codec the inputs
were read from. So even if the output channels were all over the place
(and repeatably all over the place), they should be all over the place
in the same way for each codec. This was not what I got. Each codec
was all over the place in its own unique but repeatable way!!!
So can anyone suggest a way I can visualize which channels have signal
in the WAV files, without the bizarre remapping done by vlc or
PulseAudio Volume Meter?
Steve
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
