From: "Damien.Horsley" <Damien.Horsley@xxxxxxxxxx>
Add binding document for Imagination Technologies I2S output
controller
Signed-off-by: Damien.Horsley <Damien.Horsley@xxxxxxxxxx>
---
.../devicetree/bindings/sound/img,i2s-out.txt | 51 ++++++++++++++++++++++
1 file changed, 51 insertions(+)
create mode 100644 Documentation/devicetree/bindings/sound/img,i2s-out.txt
diff --git a/Documentation/devicetree/bindings/sound/img,i2s-out.txt b/Documentation/devicetree/bindings/sound/img,i2s-out.txt
new file mode 100644
index 0000000..0159415
--- /dev/null
+++ b/Documentation/devicetree/bindings/sound/img,i2s-out.txt
@@ -0,0 +1,51 @@
+Imagination Technologies I2S Output Controller
+
+Required Properties:
+
+ - compatible : Compatible list, must contain "img,i2s-out"
+
+ - #sound-dai-cells : Must be equal to 0
+
+ - reg : Offset and length of the register set for the device
+
+ - clocks : Contains an entry for each entry in clock-names
+
+ - clock-names : Must include the following entries:
+ "sys" The system clock
+ "ref" The reference clock
+
+ - dmas: Contains an entry for each entry in dma-names.
+
+ - dma-names: Must include the following entry:
+ "tx" Single DMA channel used by all active I2S channels
+
+ - img,i2s-channels : Number of I2S channels instantiated in the I2S out block
+
+ - resets: Contains a phandle to the I2S out reset signal
+
+ - reset-names: Contains the reset signal name "rst"
+
+Optional Properties:
+
+ - interrupts : Contains the I2S out interrupts. Depending on
+ the configuration, there may be no interrupts, one interrupt,
+ or an interrupt per I2S channel. For the case where there is
+ one interrupt per channel, the interrupts should be listed
+ in ascending channel order
+
+Example:
+
+i2s_out: i2s-out@18100A00 {
+ compatible = "img,i2s-out";
+ reg = <0x18100A00 0x200>;
+ interrupts = <GIC_SHARED 13 IRQ_TYPE_LEVEL_HIGH>;
+ dmas = <&mdc 23 0xffffffff 0>;
+ dma-names = "tx";
+ clocks = <&cr_periph SYS_CLK_I2S_OUT>,
+ <&clk_core CLK_I2S>;
+ clock-names = "sys", "ref";
+ img,i2s-channels = <6>;
+ resets = <&pistachio_reset PISTACHIO_RESET_I2S_OUT>;
+ reset-names = "rst";
+ #sound-dai-cells = <0>;
+};
--
2.1.4
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
