Dear Rick Mann, On Fri, Oct 30, 2015 at 6:45 AM, Rick Mann <rmann@xxxxxxxxxxxxxxx> wrote: > >> On Oct 29, 2015, at 20:43 , Caleb Crome <caleb@xxxxxxxxx> wrote: >> >> The data sheets for those aic codecs are pretty good I think. >> >> Also, routing direct or through a mixer will be a minor difference, not a major one. >> >> It just occurred to me, the noise could easily be coming from a direct input -> output route, bypassing the adc and dac altogether. Make sure all bypass routes are zeroed out. The trick is correlating the datasheet routes with the alsa mixer controls that correspond to them . Enough staring at the aic3x.c files will eventually shed light:-) > > I've zeroed out everything I could find. Nothing had an effect until I got to the DAC muxes, at which point the behavior gets really weird. Changing those gets me to left or right output, but never both again until I reset the CODEC. > > None of this affected the hiss. Can you try `alsactl restore` with this asound.state? https://gist.github.com/bthebaudeau/e00492ebf0309f8dbace TI's diagram in the data sheet is missing a few things. Some paths are also wrong. The description of the registers is right however, so it is the reference. I have used extensively a similar setup with an older kernel, and it works fine. Best regards, Benoît _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
