Liam Girdwood wrote:
> On Fri, 2010-09-24 at 11:31 -0500, Lopez Cruz, Misael wrote:
> > Hi Jarkko,
> >
> > > ASoC Multi-Component Support moves some code from
> > > sound/soc/omap/zoom2.c
> > > into
> > > arch/arm/mach-omap2/board-zoom2.c. However, that code should go to
> > > board-zoom-peripherals.c instead as there is common code and
> > > registration
> > > for zoom boards.
> > >
> > > Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx>
> > > Cc: Vikram Pandita <vikram.pandita@xxxxxx>
> > > Cc: Lopez Cruz, Misael <x0052729@xxxxxx>
> > > Cc: Jorge Eduardo Candelaria <jorge.candelaria@xxxxxx>
> > > Cc: Tony Lindgren <tony@xxxxxxxxxxx>
> > > ---
> > > I don't have this HW so not tested.
> > Tested on zoom2 using the 2 patches of your series, compilation break is
> > gone and audio works fine.
> >
> > Thanks,
> > -Misael
>
> Applied, and manually added your Tested-by:
>
> Thanks
>
> Liam
Misael, Liam,
Sorry I noticed this patch only now. I have a minor comment on the patch:
Specifically, the part below
+ if (machine_is_omap_zoom2()) {
+ zoom_audio_data.ramp_delay_value = 3; /* 161 ms */
+ zoom_audio_data.hs_extmute = 1;
+ zoom_audio_data.set_hs_extmute = zoom2_set_hs_extmute;
+ }
Isn't the audio on a zoom2/zoom3/3630 SDP the same? (Or at least the
same on a zoom2 and zoom3)? If so, we could probably get rid of the
machine_is_omap_zoom2() check, right?
- Anand
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
