Purpose of this virtual Detection pin is to keep codec bias on whenever the
GPIO or jack detection features are needed.
Jack detection needs a mic bias so machine drivers can construct a following
route for instance for keeping the path and codec bias on:
"Input Jack" -> "Mic Bias xV" -> "Detection" -> detection block inside codec.
For the GPIO the machine driver can force the pin on with
snd_soc_dapm_force_enable_pin.
Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx>
---
PLL is activated when in SND_SOC_BIAS_PREPARE or _ON so it could be running
but I have a vague impression that it's active only when ADC or DAC is on.
I don't have at the moment possibility to measure it and don't want to move
it to DAPM either before doing some oscilloscope and pop & clicks measurements.
Current consumption anyway doesn't differ between standby and on when there is
no active stream and other widgets are off.
---
sound/soc/codecs/tlv320aic3x.c | 8 ++++++++
1 files changed, 8 insertions(+), 0 deletions(-)
diff --git a/sound/soc/codecs/tlv320aic3x.c b/sound/soc/codecs/tlv320aic3x.c
index 7b5f159..6190351 100644
--- a/sound/soc/codecs/tlv320aic3x.c
+++ b/sound/soc/codecs/tlv320aic3x.c
@@ -605,6 +605,14 @@ static const struct snd_soc_dapm_widget aic3x_dapm_widgets[] = {
SND_SOC_DAPM_INPUT("LINE1R"),
SND_SOC_DAPM_INPUT("LINE2L"),
SND_SOC_DAPM_INPUT("LINE2R"),
+
+ /*
+ * Virtual output pin to detection block inside codec. This can be
+ * used to keep codec bias on if gpio or detection features are needed.
+ * Force pin on or construct a path with an input jack and mic bias
+ * widgets.
+ */
+ SND_SOC_DAPM_OUTPUT("Detection"),
};
static const struct snd_soc_dapm_widget aic3007_dapm_widgets[] = {
--
1.7.1
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
