On Wed, 5 May 2010 09:30:22 +0300 Peter Ujfalusi <peter.ujfalusi@xxxxxxxxx> wrote: > Also, tlv320aic3x driver will try to set the defaults to the codec during the > i2c probing. I'm not sure, but if the reset line is low at that point it may > cause problems (reset line is low, and the reset sequence has not been > followed). > Than later in the machine driver the chip is taken out from reset, which might > means, that the chip will be in reset state, so the initial configuration done > by the codec driver might be lost. > > I think it would be better to handle the reset GPIO within the codec driver at > the end for proper operation. > > What do you think? > Thanks! Definitely reset handling is better to move to codec driver. Especially important if starting to manage digital voltages there. I'll cook up updated versions. -- Jarkko _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
