On 2/3/2010 8:35 μμ, Daniel Mack wrote: > On Tue, Mar 02, 2010 at 11:13:04AM +0200, adelias wrote: >> Thanks to all involved for working on usb audio v2. >> >> Last night I installed the 20100226 snapshot. I did a little testing >> with my XMOS board using toslink out into may DAC. I tried various files >> ranging 16bit/44110kHz-24bit/192000kHz. The 44110 files had quite a bit >> of static, the higher bitrate files were better. As you stated the >> sampling rate is not correct and be verified by looking at the flashing >> LEDs on the XMOS board. They should flash faster as sampling rate >> increase. In this case no change was observed. > > Yes - this is all do be done. The sample rate setting is done with a > different type of class request, which also addresses the interface now, > unlike v1 devices which send that to the endpoint. But that's just one > out of many differences that need to be addressed, and it's still a long > way to go. I'm on it :) > > Daniel I upgraded alsa to 1.0.23. The XMOS device is working great with the exception of some mild clicks here and there. Is this a known issue or might it be a problem with my specific configuration? _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
