When the DAC33 FIFO is in use the dai interface is running in
much higher speed than the sampling frequency.
Calculate the rate based on the internal base frequency and
the bclk divider.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxxxxx>
---
sound/soc/codecs/tlv320dac33.c | 5 +++++
1 files changed, 5 insertions(+), 0 deletions(-)
diff --git a/sound/soc/codecs/tlv320dac33.c b/sound/soc/codecs/tlv320dac33.c
index 725be4c..7a3dea6 100644
--- a/sound/soc/codecs/tlv320dac33.c
+++ b/sound/soc/codecs/tlv320dac33.c
@@ -53,6 +53,8 @@
#define MODE7_LTHR 10
#define MODE7_UTHR (DAC33_BUFFER_SIZE_SAMPLES - 10)
+#define BURST_BASEFREQ_HZ 49152000
+
static struct snd_soc_codec *tlv320dac33_codec;
enum dac33_state {
@@ -95,6 +97,7 @@ struct tlv320dac33_priv {
enum dac33_fifo_modes fifo_mode;/* FIFO mode selection */
unsigned int nsample; /* burst read amount from host */
u8 burst_bclkdiv; /* BCLK divider value in burst mode */
+ unsigned int burst_rate; /* Interface speed in Burst modes */
int keep_bclk; /* Keep the BCLK continuously running
* in FIFO modes */
@@ -1245,6 +1248,8 @@ static int __devinit dac33_i2c_probe(struct i2c_client *client,
dac33->power_gpio = pdata->power_gpio;
dac33->burst_bclkdiv = pdata->burst_bclkdiv;
+ /* Pre calculate the burst rate */
+ dac33->burst_rate = BURST_BASEFREQ_HZ / dac33->burst_bclkdiv / 32;
dac33->keep_bclk = pdata->keep_bclk;
dac33->irq = client->irq;
dac33->nsample = NSAMPLE_MAX;
--
1.7.0.4
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
