On Friday, February 26, 2010 3:27 PM Mark Brown wrote:
> On Fri, Feb 26, 2010 at 03:04:22PM -0600, Olaya, Margarita wrote:
>
>> In both cases if READYINIT is not set before the timeout runs out
>> it means the codec is not powering on and the driver reports an
>> error.
>
> That's kind of my point - because you're checking for the same
> status there shouldn't be any need to special case the situation
> where there's
> no interrupt, I'd expect to be able to use
> wait_for_timeout_interruptible()
> for the delay and have the timeout completion interrupt cause
> that to be
> signalled. No *terribly* important but it makes it clearer
> what's going
> on.
Do you mean something like this?
time_left = wait_for_completion_timeout(&priv->ready,
msecs_to_jiffies(48));
if(!time_left) {
twl_i2c_read_u8(TWL4030_MODULE_AUDIO_VOICE, &intid,
TWL6040_REG_INTID);
if (!(intid & TWL6040_READYINT))
goto error;
}
return 0;
error:
dev_err(codec->dev, "timeout waiting for READYINT\n");
return -ETIMEDOUT;
but in this case will it not take unnecessarily 48ms when the
interruption line is not valid?
Regards,
Margarita
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
