Hello. > -----Original Message----- > From: davinci-linux-open-source-bounces@xxxxxxxxxxxxxxxxxxxx [mailto:davinci-linux-open-source- ... > On DA850/OMAPL138 the McASP AMUTE pin is multiplexed with UART2_RTS. > As a consequence, I believe, of the below additions when the kernel is built with > SOC audio support the ttyS2 console stops accepting input after boot. > > Moreover on the EVM the AMUTE pin is only connected to headers AFAICT. > Specifically I think the DA850_AMUTE pin can be removed from below without > any loss of audio functionality while preserving console input. > > > +const short da850_mcasp_pins[] __initdata = { > > + DA850_AHCLKX, DA850_ACLKX, DA850_AFSX, > > + DA850_AHCLKR, DA850_ACLKR, DA850_AFSR, DA850_AMUTE, > > + DA850_AXR_11, DA850_AXR_12, > > + -1 > > +}; Looking more deeply I see that the board setting intent is to use UART2 in 3-wire mode with no flow control. After setting my serial port appropriately I don't see a problem with leaving AMUTE as a McASP pin. Sorry for noise. -Martin _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
