Hallo,
i have question about controlnames, or if i correctly understand it:
Capture Source - you can capture only from one of two (or more) sources.
On switching mic a or mic b will be enabled or disabled.
/--(o)--mic b
cap switch---
\--(x)--mic a
Input Source - same as capture source but more verbose
/---(Mute/Vol)--Mic a
input switch--(a(x)/b(o))--
\---(Mute/Vol)--Mic b
more complicated setup:
+---(Mute/Vol)--Mic a
input switch a-(a(x)/b(o))--+
+---(Mute/Vol)--Mic b
input switch b-(a(x)/b(o))--+
jack mode - you can choice to put VREF on the line or not.
/---(Mute/Vol)-(mode)-Mic a
input switch--(a(x)/b(o))--
\---(Mute/Vol)-(mode)-Mic b
i hope i understand it correctly.
Now is my situation:
+---------+--(Mute/Rec)-(mode)-Mic a
input switch a-(a(x)/b(o)/mix(o))--+ |
+---------+--(Mute/Rec)-(mode)-Mic b
input switch b-(a(x)/b(o)/mix(o))--+ |
+--mixer--+<---(Mute/Vol for Mic a/b)
are there any way to make alsamixer less verbose but still productive?
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
