Am Sonntag, den 06.12.2009, 01:47 -0200 schrieb Paulo Cavalcanti: > On Sat, Dec 5, 2009 at 8:14 PM, Alexey Fisher > <bug-track@xxxxxxxxxxxxxxxxx>wrote: > > > Am Mittwoch, den 02.12.2009, 11:30 +0100 schrieb Alexey Fisher: > > > Am Dienstag, den 01.12.2009, 16:49 +0100 schrieb Takashi Iwai: > > > > At Tue, 01 Dec 2009 16:45:35 +0100, > > > > Alexey Fisher wrote: > > > > > > > > > > Am Dienstag, den 01.12.2009, 16:03 +0100 schrieb Takashi Iwai: > > > > > > At Mon, 30 Nov 2009 09:06:40 +0100, > > > > > > Alexey Fisher wrote: > > > > > > > > > > > > > > Hi, > > > > > > > i recently tried to digitalise some tapes and found line-in not > > enabled > > > > > > > on my board (Intel DG45ID). (Codec: IDT 92HD73E1X5) > > > > > > > >From the board documentation i know blue jack used for line-in > > or side > > > > > > > surround. Even i use normal stereo i can't enable line-in. > > > > > > > > > > > > > > So my question, is it really to make a switch between surround > > and > > > > > > > stereo with line-in? I know it should be possible. Or to have > > this > > > > > > > switch for mic input? > > > > > > > > > > > > Which ALSA driver version are you using? > > > > > > > > > > > > The very latest one should have a "Line Jack Mode", with which you > > > > > > can change the input/output via enum control. > > > > > > > > > > i use recent alsa-kernel.git, i found this switch. > > > > > > > > Check sound GIT tree, to be sure: > > > > git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6.git > > > > > > > > A snapshot tarball for external builds is: > > > > > > ftp://ftp.kernel.org/pub/linux/kernel/people/tiwai/snapshot/alsa-driver-snapshot.tar.gz > > > > > > > > > Currently i trying to > > > > > dig deeper in the code. Seems like this board is not really > > supported... > > > > > for normal tasks like stereo in / stereo out - is ok, but surround > > seems > > > > > to be messed up, mixer map too. > > > > > For example: "speaker-test -c 6" will produce "Front L/R" on all > > jacks. > > > > > > > > You have to pass -Dsurround51, too. > > > > > > Tank you for the tip, speaker-test worked for my Hercules so i thout > > > should work for intel too. So with tiwai.git and -Dsurround51 or > > > surrounf71 outputs are working. Bad the mixer map is in really bad > > > state. Here is my current investigation, here are the controls i tested: > > > > > > [jack] [surround]; [mixers;...] > > > green - front r/l;Master; PCM; Speeker 0; > > > blue - side r/l ------- PCM; Speaker 3; > > > black - rear r/l; Master; PCM; Speaker 1; > > > orange - cenrat f/r; Master; PCM; ------; swap; > > > ('Swap Center/LFE Playback Switch' (change front and reare outputs)) > > > > I need help, > > > > one and half problem solved: > > hp_out and mic_in didn't worked on front panel, > > mic was silent, and hp did only high frequency noise (sound like > > something wrong). > > Now front and rear mic working. hp don't do the noise any more but i > > still can't get any output from it. > > Mixer is working now too, so i can use three inputs together, but it > > seems not supported by driver, so i force selection with: > > hda-verb /dev/snd/hwC0D2 0x20 SET_CONNECT_SEL 0x0b > > > > I used .ini file from windows to set it up, see attachment. There is > > cadec dump before and after tweaks, and patch. > > > > > > > http://mailman.alsa-project.org/pipermail/alsa-devel/2009-February/014825.html > Thank you, now it is working, currently only SPDIF not checked. i do not wont to touch blue jack, there is ready two mic inputs and you can switch on each of them between mic and line-in. If i'll make blue jack - line in, it will reduce surround 7.1 to 5.1. Probably not all will be happy about this. _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
