On 11 May 2009, at 12:41, Joonyoung Shim <jy0922.shim@xxxxxxxxxxx>
wrote:
> On 5/11/2009 3:53 PM, Peter Ujfalusi wrote:
>> On Thursday 30 April 2009 10:20:16 ext Joonyoung Shim wrote:
>>> On 4/30/2009 3:51 PM, Peter Ujfalusi wrote:
>>>> On Wednesday 29 April 2009 03:19:21 ext Joonyoung Shim wrote:
>>>>> I read it at TRM too, but cannot believe it such mixer of outputs.
>>>>>
>>>>> Actually, i setted to 1 both HSMIC_EN bit and MAINMIC_EN bit for
>>>>> the
>>>>> ANAMICL register, and recorded sound from headset mic and main
>>>>> mic. The
>>>>> result is that both sounds are recorded.
>>>>>
>>>>> So, to be sure this part, can you inquire about it to TI side?
>>>> I'll ask Ti about this and also about the output mixer/mux thing,
>>>> just to
>>>> be sure that we are not doing anything 'illegal' with those either.
>>>>
>>>> We should wait with this until Ti responds, I'll let you know
>>>> what is
>>>> their opinion...
>>> Ok, i see.
>>>
>>> Thanks.
>>
>> I got the response for this:
>> On the output side: ear, predive, HS, Carkit is mixable, but the
>> mixing is
>> summing and not averaging, so if the inputs are close to full, it
>> may cause
>> saturation.
>>
>> On the input side: you are right, the inputs can be mixed, but if
>> we enable
>> more than one input at the same time, the input impedance of the
>> input
>> amplifier will be reduced.
>>
>> Just in case, can you resend the patch?
>>
>
> Ok, i resend the patch. Thanks.
Peter, are you OK with this? You asked for it to be resent so I guess
you wanted to re-review it or something?
>
>
> --
> From: Joonyoung Shim <jy0922.shim@xxxxxxxxxxx>
> Date: Mon, 11 May 2009 20:36:08 +0900
> Subject: [PATCH] ASoC: TWL4030: change DAPMs for analog microphone
> selection
>
> The inputs of the twl4030 codec can be mixed, so we will use the mixer
> DAPM for the analog microphone registers(0x05, 0x06), but if we enable
> more than one input at the same time, the input impedance of the input
> amplifier will be reduced.
>
> Signed-off-by: Joonyoung Shim <jy0922.shim@xxxxxxxxxxx>
> ---
> sound/soc/codecs/twl4030.c | 52 +++++++++++++++
> +---------------------------
> 1 files changed, 19 insertions(+), 33 deletions(-)
>
> diff --git a/sound/soc/codecs/twl4030.c b/sound/soc/codecs/twl4030.c
> index fd392c6..eaf91ab 100644
> --- a/sound/soc/codecs/twl4030.c
> +++ b/sound/soc/codecs/twl4030.c
> @@ -422,36 +422,18 @@ static const struct snd_kcontrol_new
> twl4030_dapm_vibrapath_control =
> SOC_DAPM_ENUM("Route", twl4030_vibrapath_enum);
>
> /* Left analog microphone selection */
> -static const char *twl4030_analoglmic_texts[] =
> - {"Off", "Main mic", "Headset mic", "AUXL", "Carkit mic"};
> -
> -static const unsigned int twl4030_analoglmic_values[] =
> - {0x0, 0x1, 0x2, 0x4, 0x8};
> -
> -static const struct soc_enum twl4030_analoglmic_enum =
> - SOC_VALUE_ENUM_SINGLE(TWL4030_REG_ANAMICL, 0, 0xf,
> - ARRAY_SIZE(twl4030_analoglmic_texts),
> - twl4030_analoglmic_texts,
> - twl4030_analoglmic_values);
> -
> -static const struct snd_kcontrol_new
> twl4030_dapm_analoglmic_control =
> -SOC_DAPM_VALUE_ENUM("Route", twl4030_analoglmic_enum);
> +static const struct snd_kcontrol_new
> twl4030_dapm_analoglmic_controls[] = {
> + SOC_DAPM_SINGLE("Main mic", TWL4030_REG_ANAMICL, 0, 1, 0),
> + SOC_DAPM_SINGLE("Headset mic", TWL4030_REG_ANAMICL, 1, 1, 0),
> + SOC_DAPM_SINGLE("AUXL", TWL4030_REG_ANAMICL, 2, 1, 0),
> + SOC_DAPM_SINGLE("Carkit mic", TWL4030_REG_ANAMICL, 3, 1, 0),
> +};
>
> /* Right analog microphone selection */
> -static const char *twl4030_analogrmic_texts[] =
> - {"Off", "Sub mic", "AUXR"};
> -
> -static const unsigned int twl4030_analogrmic_values[] =
> - {0x0, 0x1, 0x4};
> -
> -static const struct soc_enum twl4030_analogrmic_enum =
> - SOC_VALUE_ENUM_SINGLE(TWL4030_REG_ANAMICR, 0, 0x5,
> - ARRAY_SIZE(twl4030_analogrmic_texts),
> - twl4030_analogrmic_texts,
> - twl4030_analogrmic_values);
> -
> -static const struct snd_kcontrol_new
> twl4030_dapm_analogrmic_control =
> -SOC_DAPM_VALUE_ENUM("Route", twl4030_analogrmic_enum);
> +static const struct snd_kcontrol_new
> twl4030_dapm_analogrmic_controls[] = {
> + SOC_DAPM_SINGLE("Sub mic", TWL4030_REG_ANAMICR, 0, 1, 0),
> + SOC_DAPM_SINGLE("AUXR", TWL4030_REG_ANAMICR, 1, 1, 0),
> +};
>
> /* TX1 L/R Analog/Digital microphone selection */
> static const char *twl4030_micpathtx1_texts[] =
> @@ -1138,11 +1120,15 @@ static const struct snd_soc_dapm_widget
> twl4030_dapm_widgets[] = {
> SND_SOC_DAPM_POST_PMU|SND_SOC_DAPM_POST_PMD|
> SND_SOC_DAPM_POST_REG),
>
> - /* Analog input muxes with switch for the capture amplifiers */
> - SND_SOC_DAPM_VALUE_MUX("Analog Left Capture Route",
> - TWL4030_REG_ANAMICL, 4, 0, &twl4030_dapm_analoglmic_control),
> - SND_SOC_DAPM_VALUE_MUX("Analog Right Capture Route",
> - TWL4030_REG_ANAMICR, 4, 0, &twl4030_dapm_analogrmic_control),
> + /* Analog input mixers for the capture amplifiers */
> + SND_SOC_DAPM_MIXER("Analog Left Capture Route",
> + TWL4030_REG_ANAMICL, 4, 0,
> + &twl4030_dapm_analoglmic_controls[0],
> + ARRAY_SIZE(twl4030_dapm_analoglmic_controls)),
> + SND_SOC_DAPM_MIXER("Analog Right Capture Route",
> + TWL4030_REG_ANAMICR, 4, 0,
> + &twl4030_dapm_analogrmic_controls[0],
> + ARRAY_SIZE(twl4030_dapm_analogrmic_controls)),
>
> SND_SOC_DAPM_PGA("ADC Physical Left",
> TWL4030_REG_AVADC_CTL, 3, 0, NULL, 0),
> --
> 1.6.0.4
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
