Manisha Sankpal wrote: > I am using salsa library to capture the data from the sound card. The > requirement is that the recording should be done from line-in port of the > sound card. The selection of "Line-in" port should be done programatically. > > With ALSA library, I am able to select the line-in by calling > snd_mixer_selem_set_capture_switch_all() function. However, this function > is returning an error when SALSA library is used. The high-level mixer functions are not implemented in the SALSA library. > Is there any other function/way to select the line-in mixer element in > the SALSA API? You'll have to use the snd_ctl* functions. To change the value of a mixer control, do something like this: snd_ctl_t *ctl; snd_ctl_elem_value_t *value; int onoff = 1; /* or 0 for off */ err = snd_ctl_open(&ctl, "default", 0); ... snd_ctl_elem_value_alloca(&value); ... snd_ctl_elem_value_set_interface(value, SND_CTL_ELEM_IFACE_MIXER); snd_ctl_elem_value_set_name(value, "xxxxx Capture Switch"); snd_ctl_elem_value_set_boolean(value, 0, onoff); err = snd_ctl_elem_write(ctl, value); ... snd_ctl_close(ctl); You have to use the correct name; the names of mixer controls can be seen in the output of "amixer controls". If your hardware has a single "Capture Source" control instead, you have to replace _set_boolean with _set_enumerated and use the correct index. HTH Clemens _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
