thank you, I'll try it and let you know how it went On Thu, Apr 2, 2009 at 10:56 AM, Jarkko Nikula <jhnikula@xxxxxxxxx> wrote: > On Thu, 2 Apr 2009 13:20:36 +0300 > Jarkko Nikula <jhnikula@xxxxxxxxx> wrote: > > > > Grrr... cannot find the hack, I'm too keen to delete temporary > > > hacks. I was > > pretty sure I had > > it somewhere. > > > > Basically it was adding necessary pin multiplexing configuration into > > arch/arm/plat-omap/include/mach/mux.h and arch/arm/mach-omap2/mux.c > > and then using omap_cfg_reg(...) in omap3beagle.c to change pin > > configuration from > > GPIOs to McBPS[1 | 3] pins. > > > Yes, I found it. Hack attached :-) > > Now I don't have here Beagle to test but hack still applies on top of > linux-omap. Then you will need CONFIG_OMAP_MUX=y and following lines > into omap3beagle.c or board-omap3beagle.c. > > omap_cfg_reg(AF6_3430_MCBSP3_DX); > omap_cfg_reg(AE6_3430_MCBSP3_DR); > omap_cfg_reg(AF5_3430_MCBSP3_CLKX); > omap_cfg_reg(AE5_3430_MCBSP3_FSX); > > > Jarkko > > _______________________________________________ > Alsa-devel mailing list > Alsa-devel@xxxxxxxxxxxxxxxx > http://mailman.alsa-project.org/mailman/listinfo/alsa-devel > > -- ___________ EhTd _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
