ALC889 has two SPDIF outputs: 0x06, 0x10. Board vendors can use either or both.
DX58SO uses 0x10, but the driver assumes 0x06. The safe solution is to add
0x10 as slave output to the existing 0x06.
Reported-by: Jeroen Van Breedam <jeroen.vanbreedam@xxxxxxx>
Tested-by: Jeroen Van Breedam <jeroen.vanbreedam@xxxxxxx>
Signed-off-by: Wu Fengguang <fengguang.wu@xxxxxxxxx>
---
sound/pci/hda/patch_realtek.c | 5 +++++
1 file changed, 5 insertions(+)
--- sound-2.6.orig/sound/pci/hda/patch_realtek.c
+++ sound-2.6/sound/pci/hda/patch_realtek.c
@@ -8764,6 +8764,10 @@ static struct snd_pci_quirk alc883_cfg_t
{}
};
+static hda_nid_t alc883_slave_dig_outs[] = {
+ ALC1200_DIGOUT_NID, 0,
+};
+
static hda_nid_t alc1200_slave_dig_outs[] = {
ALC883_DIGOUT_NID, 0,
};
@@ -8809,6 +8813,7 @@ static struct alc_config_preset alc883_p
.dac_nids = alc883_dac_nids,
.dig_out_nid = ALC883_DIGOUT_NID,
.dig_in_nid = ALC883_DIGIN_NID,
+ .slave_dig_outs = alc883_slave_dig_outs,
.num_channel_mode = ARRAY_SIZE(alc883_3ST_6ch_intel_modes),
.channel_mode = alc883_3ST_6ch_intel_modes,
.need_dac_fix = 1,
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
