The sdw_initialize_slave() function stores 'slave->prop' as local 'prop'
variable, so use it in all applicable places to make code a bit simpler.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
drivers/soundwire/bus.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/soundwire/bus.c b/drivers/soundwire/bus.c
index 191e6cc6f962..263ca32f0c5c 100644
--- a/drivers/soundwire/bus.c
+++ b/drivers/soundwire/bus.c
@@ -1410,7 +1410,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave)
}
}
if ((slave->bus->prop.quirks & SDW_MASTER_QUIRKS_CLEAR_INITIAL_PARITY) &&
- !(slave->prop.quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) {
+ !(prop->quirks & SDW_SLAVE_QUIRKS_INVALID_INITIAL_PARITY)) {
/* Clear parity interrupt before enabling interrupt mask */
status = sdw_read_no_pm(slave, SDW_SCP_INT1);
if (status < 0) {
@@ -1436,7 +1436,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave)
* device-dependent, it might e.g. only be enabled in
* steady-state after a couple of frames.
*/
- val = slave->prop.scp_int1_mask;
+ val = prop->scp_int1_mask;
/* Enable SCP interrupts */
ret = sdw_update_no_pm(slave, SDW_SCP_INTMASK1, val, val);
@@ -1447,7 +1447,7 @@ static int sdw_initialize_slave(struct sdw_slave *slave)
}
/* No need to continue if DP0 is not present */
- if (!slave->prop.dp0_prop)
+ if (!prop->dp0_prop)
return 0;
/* Enable DP0 interrupts */
--
2.43.0
