Timeslots setting is done at channel start() and stop(). There is no more need to do that during setup_chan(). Simply remove timeslot setting from setup_chan(). Signed-off-by: Herve Codina <herve.codina@xxxxxxxxxxx> Reviewed-by: Christophe Leroy <christophe.leroy@xxxxxxxxxx> --- drivers/soc/fsl/qe/qmc.c | 28 ---------------------------- 1 file changed, 28 deletions(-) diff --git a/drivers/soc/fsl/qe/qmc.c b/drivers/soc/fsl/qe/qmc.c index e56aea5803bf..73903ce31695 100644 --- a/drivers/soc/fsl/qe/qmc.c +++ b/drivers/soc/fsl/qe/qmc.c @@ -723,30 +723,6 @@ static int qmc_chan_setup_tsa_rx(struct qmc_chan *chan, bool enable) return qmc_chan_setup_tsa_32rx(chan, &info, enable); } -static int qmc_chan_setup_tsa(struct qmc_chan *chan, bool enable) -{ - struct tsa_serial_info info; - int ret; - - /* Retrieve info from the TSA related serial */ - ret = tsa_serial_get_info(chan->qmc->tsa_serial, &info); - if (ret) - return ret; - - /* - * Setup one common 64 entries table or two 32 entries (one for Tx - * and one for Tx) according to assigned TS numbers. - */ - if (chan->qmc->is_tsa_64rxtx) - return qmc_chan_setup_tsa_64rxtx(chan, &info, enable); - - ret = qmc_chan_setup_tsa_32rx(chan, &info, enable); - if (ret) - return ret; - - return qmc_chan_setup_tsa_32tx(chan, &info, enable); -} - static int qmc_chan_command(struct qmc_chan *chan, u8 qmc_opcode) { return cpm_command(chan->id << 2, (qmc_opcode << 4) | 0x0E); @@ -1323,10 +1299,6 @@ static int qmc_setup_chan(struct qmc *qmc, struct qmc_chan *chan) chan->qmc = qmc; - ret = qmc_chan_setup_tsa(chan, true); - if (ret) - return ret; - /* Set channel specific parameter base address */ chan->s_param = qmc->dpram + (chan->id * 64); /* 16 bd per channel (8 rx and 8 tx) */ -- 2.42.0