2 mono speaker setup fixes: 1. Use the kernel's components string to check for a mono-speaker device when the board has a components string. 2. So far known nau8824 boards with a mono speaker where using the right speaker channel, which is unusual. Normally mono speaker setups use only the left speaker channel. The Cyberbook T116 tablet is a nau8824 based model, which indeed uses the left speaker channel for its single speaker. Modify ucm2/codecs/nau8824/MonoSpeaker.conf to send a left+right channel mix to both speaker channels, so that things will work independent of which speaker channel is used for a mono setup. Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- ucm2/Intel/chtnau8824/HiFi.conf | 15 +++++++++++++++ ucm2/codecs/nau8824/MonoSpeaker.conf | 7 ++++--- 2 files changed, 19 insertions(+), 3 deletions(-) diff --git a/ucm2/Intel/chtnau8824/HiFi.conf b/ucm2/Intel/chtnau8824/HiFi.conf index c3d830d..1a1faf4 100644 --- a/ucm2/Intel/chtnau8824/HiFi.conf +++ b/ucm2/Intel/chtnau8824/HiFi.conf @@ -14,6 +14,21 @@ If.Controls { } } +# Figure out which components are in use on the device, we check both the +# components string (present on newer kernels) as well as checking for DMI +# strings for compatibility with older kernels. Note DMI matches for new +# models should only be added to the kernel, this UCM profile will then +# automatically pick up the info from the components string. + +If.components-mono-spk { + Condition { + Type String + Haystack "${CardComponents}" + Needle "cfg-spk:1" + } + True.Define.Speaker "MonoSpeaker" +} + If.cfg-mspk { Condition { Type RegexMatch diff --git a/ucm2/codecs/nau8824/MonoSpeaker.conf b/ucm2/codecs/nau8824/MonoSpeaker.conf index 6b4ef8a..5428133 100644 --- a/ucm2/codecs/nau8824/MonoSpeaker.conf +++ b/ucm2/codecs/nau8824/MonoSpeaker.conf @@ -11,9 +11,10 @@ SectionDevice."Speaker" { ] EnableSequence [ - # nau8824 mono speaker boards have the speaker on the right chan - cset "name='Speaker Left DACL Volume' 0" - cset "name='Speaker Left DACR Volume' 0" + # Some nau8824 mono speaker boards have the speaker on the right chan + # others on the left, enable output of both channels on both speakers + cset "name='Speaker Left DACL Volume' 1" + cset "name='Speaker Left DACR Volume' 1" cset "name='Speaker Right DACL Volume' 1" cset "name='Speaker Right DACR Volume' 1" cset "name='Ext Spk Switch' on" -- 2.41.0