From: Chris Morgan <macromorgan@xxxxxxxxxxx> I have a board (RK3588 based) that sets the sysclk to 12287999. The es8328 driver fails to match this to the 12288000 rate and fails to load. Allow the rate comparison to work if the frequency is within 100hz by dividing it by 100 and rounding it, then multiplying it back by 100. Note the 100hz value was chosen arbitrarily by me, but it has only been tested with a 1hz difference. Signed-off-by: Chris Morgan <macromorgan@xxxxxxxxxxx> --- sound/soc/codecs/es8328.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) diff --git a/sound/soc/codecs/es8328.c b/sound/soc/codecs/es8328.c index 0bd9ba5a11b4..22e7a9312732 100644 --- a/sound/soc/codecs/es8328.c +++ b/sound/soc/codecs/es8328.c @@ -557,8 +557,15 @@ static int es8328_set_sysclk(struct snd_soc_dai *codec_dai, struct snd_soc_component *component = codec_dai->component; struct es8328_priv *es8328 = snd_soc_component_get_drvdata(component); int mclkdiv2 = 0; + unsigned int round_freq; - switch (freq) { + /* + * Allow a small tolerance for frequencies within 100hz. Note + * this value is chosen arbitrarily. + */ + round_freq = DIV_ROUND_CLOSEST(freq, 100) * 100; + + switch (round_freq) { case 0: es8328->sysclk_constraints = NULL; es8328->mclk_ratios = NULL; -- 2.34.1