On 8/11/23 11:48, Cezary Rojewski wrote: > To provide option for selecting different bit-per-sample than just the > maximum one, use the new format calculation mechanism. Can you remind me what the issue is in selecting the maximum resolution? Isn't it a good thing to select the maximum resolution when possible so as to provide more headroom and prevent clipping? Usually we try to make sure the resolution becomes limited when we reach the analog parts. I am not sure I see a compelling reason to reduce the resolution on the host side. I am also not sure what this patch actually changes, given that the firmware actually converts everything to the full 32-bit resolution. I must be missing something on the problem statement. > Signed-off-by: Cezary Rojewski <cezary.rojewski@xxxxxxxxx> > --- > sound/soc/sof/intel/hda-dai-ops.c | 5 +++-- > 1 file changed, 3 insertions(+), 2 deletions(-) > > diff --git a/sound/soc/sof/intel/hda-dai-ops.c b/sound/soc/sof/intel/hda-dai-ops.c > index f3513796c189..00703999e91b 100644 > --- a/sound/soc/sof/intel/hda-dai-ops.c > +++ b/sound/soc/sof/intel/hda-dai-ops.c > @@ -194,14 +194,15 @@ static unsigned int hda_calc_stream_format(struct snd_sof_dev *sdev, > struct snd_soc_dai *codec_dai = asoc_rtd_to_codec(rtd, 0); > unsigned int link_bps; > unsigned int format_val; > + unsigned int bps; > > if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) > link_bps = codec_dai->driver->playback.sig_bits; > else > link_bps = codec_dai->driver->capture.sig_bits; > + bps = snd_hdac_stream_format_bps(params_format(params), SNDRV_PCM_SUBFORMAT_STD, link_bps); I can't say I fully understand the difference between 'bps' and 'link_bps'. The naming is far from self-explanatory just by looking at the code. > - format_val = snd_hdac_calc_stream_format(params_rate(params), params_channels(params), > - params_format(params), link_bps, 0); > + format_val = snd_hdac_stream_format(params_channels(params), bps, params_rate(params)); > > dev_dbg(sdev->dev, "format_val=%#x, rate=%d, ch=%d, format=%d\n", format_val, > params_rate(params), params_channels(params), params_format(params));