To start capture on Microchip PDMC the enable bits for each supported
microphone need to be set. After this bit is set the PDMC starts to
receive data from microphones and it considers this data as valid data.
Thus if microphones are not ready the PDMC captures anyway data from its
lines. This data is interpreted by the human ear as poc noises.
To avoid this the following software workaround need to be applied when
starting capture:
1/ enable PDMC channel
2/ wait 150ms
3/ execute 16 dummy reads from RHR
4/ clear interrupts
5/ enable interrupts
6/ enable DMA channel
For this workaround to work step 6 need to be executed at the end.
For step 6 was added patch 1/3 from this series. With this, component
DAI driver sets its struct snd_soc_component_driver::start_dma_last = 1
and proper action is taken based on this flag when starting DAI trigger
vs DMA.
Thank you,
Claudiu Beznea
Changes in v2:
- patch 1/3 from v1 is now "ASoC: soc-pcm: add option to start DMA after DAI"
- pass start_dma_last from component DAI driver object
(struct snd_soc_component_driver::start_dma_last); adapt patch 3/3 after this;
- in patch 1/3 s/Do we need to start dma first/Do we need to start dma last
in comment from soc_pcm_trigger()
- collect review tag from Krzysztof
Claudiu Beznea (3):
ASoC: soc-pcm: add option to start DMA after DAI
ASoC: dt-bindings: sama7g5-pdmc: add microchip,startup-delay-us
binding
ASoC: mchp-pdmc: fix poc noise at capture startup
.../sound/microchip,sama7g5-pdmc.yaml | 6 ++
include/sound/soc-component.h | 2 +
sound/soc/atmel/mchp-pdmc.c | 55 +++++++++++++++++--
sound/soc/soc-pcm.c | 27 +++++++--
4 files changed, 80 insertions(+), 10 deletions(-)
--
2.34.1
