On Tue, Feb 07, 2023 at 10:40:20AM +0000, Lucas Tanure wrote:
> Shared boost allows two amplifiers to share a single boost
> circuit by communicating on the MDSYNC bus.
> The passive amplifier does not control the boost and receives
> data from the active amplifier.
>
> Shared Boost is not supported in HDA Systems.
>
Probably would be nice to put at least a note to say based on
David's patches.
> +static const struct reg_sequence cs35l41_shd_boost_seq[] = {
> + {CS35L41_PWR_CTRL3, 0x01000110},
This will blat whatever the user set in the DRE switch.
Technically blats the CLASS H enable from the DAPM widget too,
but as that always turns on should be a no-op. Probably should
either not register the DRE switch or have setting it return an
error for these boost modes.
> +int cs35l41_global_enable(struct regmap *regmap, enum cs35l41_boost_type b_type, int enable,
> + struct completion *pll_lock)
> {
> int ret;
> + unsigned int gpio1;
>
> switch (b_type) {
> + case CS35L41_SHD_BOOST_ACTV:
> + case CS35L41_SHD_BOOST_PASS:
> + regmap_update_bits(regmap, CS35L41_PWR_CTRL3, CS35L41_SYNC_EN_MASK, 0);
> +
> + gpio1 = enable ? CS35L41_GPIO1_MDSYNC : CS35L41_GPIO1_HIZ;
> + regmap_update_bits(regmap, CS35L41_GPIO_PAD_CONTROL, CS35L41_GPIO1_CTRL_MASK,
> + gpio1 << CS35L41_GPIO1_CTRL_SHIFT);
> +
> + ret = regmap_update_bits(regmap, CS35L41_PWR_CTRL1, CS35L41_GLOBAL_EN_MASK,
> + enable << CS35L41_GLOBAL_EN_SHIFT);
> + usleep_range(3000, 3100);
> + if (!enable)
> + break;
> +
> + if (!pll_lock)
> + return -EINVAL;
> +
> + ret = wait_for_completion_timeout(pll_lock, msecs_to_jiffies(1000));
> + if (ret == 0)
> + ret = -ETIMEDOUT;
This feels kinda scary, in that you are relying on a 1 to 1
correspondence between this code running and getting a PLL lock
signal. The datasheet is helpfully completely vague on when PLL
locks are triggered.
The PLL enable seems to be set through set_sysclk, which could
be called multiple times, per DAPM power up. Does the PLL
lock only go once global enable has been set? Can't help
but wonder if a reinit_completion should probably go somewhere
to ensure we are getting this lock of the PLL not a past one.
> @@ -483,6 +483,11 @@ static irqreturn_t cs35l41_irq(int irq, void *data)
> ret = IRQ_HANDLED;
> }
>
> + if (status[2] & CS35L41_PLL_LOCK) {
> + regmap_write(cs35l41->regmap, CS35L41_IRQ1_STATUS3, CS35L41_PLL_LOCK);
> + complete(&cs35l41->pll_lock);
> + }
> +
If you fall into any of the error cases in this IRQ handler above
this, it will blat values you don't want into BST_EN although, to
be fair that does look currently broken for external boost as
well.
Thanks,
Charles
