From: Ranjani Sridharan <ranjani.sridharan@xxxxxxxxxxxxxxx>
Set the FW state to complete right after boot is complete. This enables
sending IPC's in the post_fw_run op. This will be needed to support
reloading 3rd party module libraries after firmware boot.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@xxxxxxxxxxxxxxx>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxxxxxxxxxxx>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@xxxxxxxxxxxxxxx>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxxxxxxxx>
Reviewed-by: Chao Song <chao.song@xxxxxxxxx>
Reviewed-by: Kai Vehmanen <kai.vehmanen@xxxxxxxxxxxxxxx>
---
sound/soc/sof/loader.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/sound/soc/sof/loader.c b/sound/soc/sof/loader.c
index 5f51d936b306..59e6be59258e 100644
--- a/sound/soc/sof/loader.c
+++ b/sound/soc/sof/loader.c
@@ -165,6 +165,9 @@ int snd_sof_run_firmware(struct snd_sof_dev *sdev)
if (sdev->fw_state == SOF_FW_BOOT_READY_FAILED)
return -EIO; /* FW boots but fw_ready op failed */
+ dev_dbg(sdev->dev, "firmware boot complete\n");
+ sof_set_fw_state(sdev, SOF_FW_BOOT_COMPLETE);
+
/* perform post fw run operations */
ret = snd_sof_dsp_post_fw_run(sdev);
if (ret < 0) {
@@ -172,9 +175,6 @@ int snd_sof_run_firmware(struct snd_sof_dev *sdev)
return ret;
}
- dev_dbg(sdev->dev, "firmware boot complete\n");
- sof_set_fw_state(sdev, SOF_FW_BOOT_COMPLETE);
-
if (sdev->first_boot && sdev->ipc->ops->fw_loader->query_fw_configuration)
return sdev->ipc->ops->fw_loader->query_fw_configuration(sdev);
--
2.38.1
