On 29/04/2022 17:19, Pierre-Louis Bossart wrote:
On 4/29/22 11:09, Srinivas Kandagatla wrote:
Currently timeout for autoenumeration during probe and bus reset is set to
2 secs which is really a big value. This can have an adverse effect on
boot time if the slave device is not ready/reset.
This was the case with wcd938x which was not reset yet but we spent 2
secs waiting in the soundwire controller probe. Reduce this time to
1/10 of Hz which should be good enough time to finish autoenumeration
if any slaves are available on the bus.
Can I ask why this is dependent on a software configuration you have no control on?
Why not simply:
#define TIMEOUT_MS 100
?
That will work too.
--srini
Reported-by: Srinivasa Rao Mandadapu <quic_srivasam@xxxxxxxxxxx>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
drivers/soundwire/qcom.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
index da1ad7ebb1aa..432e5cb9a4d2 100644
--- a/drivers/soundwire/qcom.c
+++ b/drivers/soundwire/qcom.c
@@ -105,7 +105,7 @@
#define SWRM_SPECIAL_CMD_ID 0xF
#define MAX_FREQ_NUM 1
-#define TIMEOUT_MS (2 * HZ)
+#define TIMEOUT_MS (HZ/10)
#define QCOM_SWRM_MAX_RD_LEN 0x1
#define QCOM_SDW_MAX_PORTS 14
#define DEFAULT_CLK_FREQ 9600000
