Hello > That is more or less what I had figured out, but it how are playback_1 to > > _16 channels routed to DSP0-15? It seems that it depends on the setting > of > > Front, Surround, LFE, etc. mixer controls. If they are turned up, I > don't > > understand what happens, sound to playback channels appears on various > DSP > > buses, at different levels. > > Really? Well, I didn't much experiment with surround mode. In source code, > I > can see that there are up to playback 8 channels at hw:0,0 with can be > controlled by faders in alsamixer. I tried surround40 and surroun51 on my > emu1616m and it worked as expected. The channles were mapped to first > couple > of DSP ports in a correct order. In fact this should work the same as > audigy > does, except the result is passed to DSP ports instead of physical > outputs. > On my card, playback channels 1 & 2 (hw:0,3) appear on all DSP busses associated with surround. Say you turn up the "Side" fader in alsamixer, channels 1 & 2 will appear at the relevant DSPs (6-7, I think) Whatever, for now I am just keeping all surround controls down (that is, Front, Surround, Center, Side & LFE). > Anyway, I think if there is another layer of routing done in audigy DSP, > it > shouldn't be used in EMU specific application. Or at least not for now. > The > most important thing is to provide all the switches and FPGA routing > scheme > for each EMU model. Or, to be precise, three routing schemes for each EMU > model, because for "double speed" (e.g. 96kHz) and "quadro speed" (e.g. > 192kHz) modes of operation the numebr of both physical and virtual > channels > changes. > I think the switches and enums for the card models are rather trivial, one can handle it with a customized version of qamix (done with a simple XML file), for example. A separate application would not be necessary for only that. > > If I turn the Front/Surround/LFE/etc. faders down, I can mix playback > > channels to DSP using the "Multichannel PCM Send/Routing/Volume" faders, > in > > a more or less intuitive way, besides that routing values do not map > > directly to DSP buses (i.e. 14-15 map to DSP0-1, but 2-3 map to DSP2-3). > Handling of this controls motivated me to write the application in the first place. No sound at all will appear if I don't set the appropiate controls for each playback channel: Multichannel PCM Volume (full), Multichannel PCM Send (an index of 8 controls, the first 4 select the target DSP) & Multichannel PCM Send Volume (again faders 0-3 of 8) By the way, only DSP0-7 work in this way. I have no idea how to make DSP8-31 work. On which card you did tested it? The driver was primary written for the > 1820M/1212M V1, so some things may not work well on other models and need > to > be fixed. I have a 1212m, don't know which version, but I think it's V1-- it does have firewire. I am using driver version 1.0.16. Thanks, Camilo. _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
