Re: [PATCH 1/2] platform: make platform_get_irq_optional() optional

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 1/14/22 12:25 PM, Uwe Kleine-König wrote:

>>>>> To me it sounds much more logical for the driver to check if an
>>>>> optional irq is non-zero (available) or zero (not available), than to
>>>>> sprinkle around checks for -ENXIO. In addition, you have to remember
>>>>> that this one returns -ENXIO, while other APIs use -ENOENT or -ENOSYS
>>>>> (or some other error code) to indicate absence. I thought not having
>>>>> to care about the actual error code was the main reason behind the
>>>>> introduction of the *_optional() APIs.
>>>
>>>> No, the main benefit of gpiod_get_optional() (and clk_get_optional()) is
>>>> that you can handle an absent GPIO (or clk) as if it were available.
>>
>>    Hm, I've just looked at these and must note that they match 1:1 with
>> platform_get_irq_optional(). Unfortunately, we can't however behave the
>> same way in request_irq() -- because it has to support IRQ0 for the sake
>> of i8253 drivers in arch/...
> 
> Let me reformulate your statement to the IMHO equivalent:
> 
> 	If you set aside the differences between
> 	platform_get_irq_optional() and gpiod_get_optional(),

   Sorry, I should make it clear this is actually the diff between a would-be
platform_get_irq_optional() after my patch, not the current code...

> 	platform_get_irq_optional() is like gpiod_get_optional().
> 
> The introduction of gpiod_get_optional() made it possible to simplify
> the following code:
> 
> 	reset_gpio = gpiod_get(...)
> 	if IS_ERR(reset_gpio):
> 		error = PTR_ERR(reset_gpio)
> 		if error != -ENDEV:

   ENODEV?

> 			return error
> 	else:
> 		gpiod_set_direction(reset_gpiod, INACTIVE)
> 
> to
> 
> 	reset_gpio = gpiod_get_optional(....)
> 	if IS_ERR(reset_gpio):
> 		return reset_gpio
> 	gpiod_set_direction(reset_gpiod, INACTIVE)
> 
> and I never need to actually know if the reset_gpio actually exists.
> Either the line is put into its inactive state, or it doesn't exist and
> then gpiod_set_direction is a noop. For a regulator or a clk this works
> in a similar way.
> 
> However for an interupt this cannot work. You will always have to check
> if the irq is actually there or not because if it's not you cannot just
> ignore that. So there is no benefit of an optional irq.
> 
> Leaving error message reporting aside, the introduction of
> platform_get_irq_optional() allows to change
> 
> 	irq = platform_get_irq(...);
> 	if (irq < 0 && irq != -ENXIO) {
> 		return irq;
> 	} else if (irq >= 0) {

   Rather (irq > 0) actually, IRQ0 is considered invalid (but still returned).

> 		... setup irq operation ...
> 	} else { /* irq == -ENXIO */
> 		... setup polling ...
> 	}
> 
> to
> 	
> 	irq = platform_get_irq_optional(...);
> 	if (irq < 0 && irq != -ENXIO) {
> 		return irq;
> 	} else if (irq >= 0) {
> 		... setup irq operation ...
> 	} else { /* irq == -ENXIO */
> 		... setup polling ...
> 	}
> 
> which isn't a win. When changing the return value as you suggest, it can
> be changed instead to:
> 
> 	irq = platform_get_irq_optional(...);
> 	if (irq < 0) {
> 		return irq;
> 	} else if (irq > 0) {
> 		... setup irq operation ...
> 	} else { /* irq == 0 */
> 		... setup polling ...
> 	}
> 
> which is a tad nicer. If that is your goal however I ask you to also
> change the semantic of platform_get_irq() to return 0 on "not found".

    Well, I'm not totally opposed to that... but would there be a considerable win?
Anyway, we should 1st stop returning 0 for "valid" IRQs -- this is done by my patch
the discussed patch series are atop of.

> Note the win is considerably less compared to gpiod_get_optional vs

   If there's any at all... We'd basically have to touch /all/ platform_get_irq()
calls (and get an even larger CC list ;-)).

> gpiod_get however. And then it still lacks the semantic of a dummy irq
> which IMHO forfeits the right to call it ..._optional().

   Not quite grasping it... Why e.g. clk_get() doesn't return 0 for a not found clock?

> Now I'm unwilling to continue the discussion unless there pops up a
> suggestion that results in a considerable part (say > 10%) of the
> drivers using platform_get_irq_optional not having to check if the
> return value corresponds to "not found".

   Note that many actual drivers don't follow the pattern prescribed in the comment to
platform_get_irq_optional() and their check for an optional IRQ look like irq < 0
(and, after my patches, irq <= 0). Maybe we shouldn't even bother returning the error
codes and just return 0 for all kinds of misfortunes instead? :-)

> Best regards
> Uwe

MBR, Sergey



[Index of Archives]     [ALSA User]     [Linux Audio Users]     [Pulse Audio]     [Kernel Archive]     [Asterisk PBX]     [Photo Sharing]     [Linux Sound]     [Video 4 Linux]     [Gimp]     [Yosemite News]

  Powered by Linux