On Wed, Dec 08, 2021 at 08:21:31PM +0000, Mark Brown wrote:
> On Thu, Dec 09, 2021 at 12:28:49AM +0530, Ajit Kumar Pandey wrote:
>
> > +static int speaker_mute_put(struct snd_kcontrol *kcontrol,
> > + struct snd_ctl_elem_value *ucontrol)
> > +{
> > + struct snd_soc_component *component = snd_soc_kcontrol_component(kcontrol);
> > + struct max98357a_priv *max98357a = snd_soc_component_get_drvdata(component);
> > + int mode = ucontrol->value.enumerated.item[0];
> > +
> > + max98357a->sdmode_switch = mode;
> > + gpiod_set_value_cansleep(max98357a->sdmode, mode);
> > + dev_dbg(component->dev, "set sdmode to %d", mode);
>
> This looks like it should just be a DAPM widget - it's just a generic
> GPIO control, there's no connection with the CODEC that I can see so it
> definitely shouldn't be in the CODEC driver. Often trivial stuff like
> this is done in the machine driver, though the simple-amplifier driver
> is probably a good fit here.
Actually now I look again the only control interface this driver has is
GPIOs but it does expose a digital interface with constraints as input
so doesn't fit within simple-amplifier. However this is just powering
off the amplifier to achieve mute rather than a separate mute control so
it'd probably be better to use a SND_SOC_DAPM_PIN_SWITCH() for the
Speaker widget to do this, this would also end up addressing Jaroslav's
thing with the naming as a side effect. Sorry about the confusion there.
Attachment:
signature.asc
Description: PGP signature
