At Thu, 28 Feb 2008 12:14:50 +0100, I wrote: > > At Wed, 27 Feb 2008 19:16:23 +0100, > Rene Dohmen wrote: > > > > I tried it with all avalialable NIDS: > > > > sudo ./hda-verb /dev/snd/hwC0D0 0x14 SET_EAPD 0x02 > > Is this correct? > > Looks OK. Check /proc/asound/card0/codec#0 after you run the > command. The EAPD value shown there must be changed. > > > And is it so with all module options? > > > > Yes with all tested codecs: are there any more options that i can use? > > Did you figure out that 0x14 is really the speaker output? > You can check it by muting the AMP of this widget manually via > hda-verb command. Err, disregard this comment, of course :) AFAIK, ALC268 doesn't use GPIOs for EAPD controls but only EAPD verbs. So, setting EAPD on the widget should suffice. Anyway, it'd be better to show codec#0 proc at the state you believe that you've set up correctly but no sound comes out from the speaker. Also, clarify what you've tested, too. Takashi _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
