Adrian Stancu wrote: > OK, I tried playing the stereo file but still getting the same error: > deathu@vader:~/Desktop$ aplay -D hw:1 testtone192.wav > Playing WAVE 'testtone192.wav' : Signed 16 bit Little Endian, Rate 192000 Hz, Stereo > aplay: set_params:918: Sample format non available Oops, the device supports only 24-bit samples, and this isn't supported by .wav files, so using hw:1 won't ever work with aply. > Well, my test file contained a single constant frequency tone; it is > still there while I play the 192k file through plughw:1,0, but burried > under: > - periodic series of clicks > - other high frequency tones > > Here is /proc/asound/card1/stream0 while playing through plughw:1,0: > ... > Momentary freq = 192000 Hz (0x18.0000) Does this value ever change? Could you again try inserting a printk to see whether the driver thinks it gets invalid frequency values? Regards, Clemens _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
