Changeset 5513b411ea5b ("Documentation: rename pinctl to pin-control")
renamed: Documentation/driver-api/pinctl.rst
to: Documentation/driver-api/pin-control.rst.
Update the cross-references accordingly.
Fixes: 5513b411ea5b ("Documentation: rename pinctl to pin-control")
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
---
include/linux/device.h | 2 +-
include/linux/mfd/madera/pdata.h | 2 +-
include/linux/pinctrl/pinconf-generic.h | 2 +-
3 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/include/linux/device.h b/include/linux/device.h
index 38a2071cf776..d1183cfdc8fb 100644
--- a/include/linux/device.h
+++ b/include/linux/device.h
@@ -399,7 +399,7 @@ struct dev_links_info {
* along with subsystem-level and driver-level callbacks.
* @em_pd: device's energy model performance domain
* @pins: For device pin management.
- * See Documentation/driver-api/pinctl.rst for details.
+ * See Documentation/driver-api/pin-control.rst for details.
* @msi_list: Hosts MSI descriptors
* @msi_domain: The generic MSI domain this device is using.
* @numa_node: NUMA node this device is close to.
diff --git a/include/linux/mfd/madera/pdata.h b/include/linux/mfd/madera/pdata.h
index 601cbbc10370..32e3470708ed 100644
--- a/include/linux/mfd/madera/pdata.h
+++ b/include/linux/mfd/madera/pdata.h
@@ -31,7 +31,7 @@ struct pinctrl_map;
* @irq_flags: Mode for primary IRQ (defaults to active low)
* @gpio_base: Base GPIO number
* @gpio_configs: Array of GPIO configurations (See
- * Documentation/driver-api/pinctl.rst)
+ * Documentation/driver-api/pin-control.rst)
* @n_gpio_configs: Number of entries in gpio_configs
* @gpsw: General purpose switch mode setting. Depends on the external
* hardware connected to the switch. (See the SW1_MODE field
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 6aeb711f7cd1..fdcd773adba3 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -88,7 +88,7 @@ struct pinctrl_map;
* it.
* @PIN_CONFIG_OUTPUT: this will configure the pin as an output and drive a
* value on the line. Use argument 1 to indicate high level, argument 0 to
- * indicate low level. (Please see Documentation/driver-api/pinctl.rst,
+ * indicate low level. (Please see Documentation/driver-api/pin-control.rst,
* section "GPIO mode pitfalls" for a discussion around this parameter.)
* @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
* supplies, the argument to this parameter (on a custom format) tells
--
2.30.2
