At Sun, 27 Jan 2008 23:03:20 +0100, Martin Egge wrote: > > Hi Takashi, > > Am Mittwoch, 23. Januar 2008 schrieb Takashi Iwai: > > The SPDIF is disabled intentionally for your model because no one > > could test it. Does the patch below work? > > As I already have written: this patch does not work with the code from hg. But > I've applied it successfully on 1.0.15. The digital output is working and can > be disabled with the IEC958 switch. > > Using the code from hg the digital output is not working as well when I set > model=3stack. This has has been working with the original code from 1.0.15 > and 1.0.14. So there must be a general problem with IEC958 in the hg code. OK, then again, get the codec dump to compare. > I've another question regarding the digital output. Is there a way to control > the volume of the digital output? Neither the Master nor the PCM control have > any effect on the volume of the digital output. In addition the output can't > be switched off by muting PCM or Master. No, this signal route has no volume control. Takashi _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
