The Intel Bay Trail (x86/ACPI) based Lenovo Yoga Tablet 2 series use a WM5102 codec connected over SPI. Add support for ACPI enumeration to arizona-spi so that arizona-spi can bind to the codec on these tablets. This is loosely based on an earlier attempt (for Android-x86) at this by Christian Hartmann, combined with insights in things like the speaker GPIO from the android-x86 android port for the Lenovo Yoga Tablet 2 1051F/L [1]. [1] https://github.com/Kitsune2222/Android_Yoga_Tablet_2-1051F_Kernel Cc: Christian Hartmann <cornogle@xxxxxxxxxxxxxx> Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/mfd/arizona-spi.c | 120 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 120 insertions(+) diff --git a/drivers/mfd/arizona-spi.c b/drivers/mfd/arizona-spi.c index 704f214d2614..bcdbd72fefb5 100644 --- a/drivers/mfd/arizona-spi.c +++ b/drivers/mfd/arizona-spi.c @@ -7,7 +7,10 @@ * Author: Mark Brown <broonie@xxxxxxxxxxxxxxxxxxxxxxxxxxx> */ +#include <linux/acpi.h> #include <linux/err.h> +#include <linux/gpio/consumer.h> +#include <linux/gpio/machine.h> #include <linux/module.h> #include <linux/pm_runtime.h> #include <linux/regmap.h> @@ -15,11 +18,119 @@ #include <linux/slab.h> #include <linux/spi/spi.h> #include <linux/of.h> +#include <uapi/linux/input-event-codes.h> #include <linux/mfd/arizona/core.h> #include "arizona.h" +#ifdef CONFIG_ACPI +const struct acpi_gpio_params reset_gpios = { 1, 0, false }; +const struct acpi_gpio_params ldoena_gpios = { 2, 0, false }; + +static const struct acpi_gpio_mapping arizona_acpi_gpios[] = { + { "reset-gpios", &reset_gpios, 1, }, + { "wlf,ldoena-gpios", &ldoena_gpios, 1 }, + { } +}; + +/* + * The ACPI resources for the device only describe external GPIO-s. They do + * not provide mappings for the GPIO-s coming from the Arizona codec itself. + */ +static const struct gpiod_lookup arizona_soc_gpios[] = { + { "arizona", 2, "wlf,spkvdd-ena", 0, GPIO_ACTIVE_HIGH }, + { "arizona", 4, "wlf,micd-pol", 0, GPIO_ACTIVE_LOW }, +}; + +/* + * The AOSP 3.5 mm Headset: Accessory Specification gives the following values: + * Function A Play/Pause: 0 ohm + * Function D Voice assistant: 135 ohm + * Function B Volume Up 240 ohm + * Function C Volume Down 470 ohm + * Minimum Mic DC resistance 1000 ohm + * Minimum Ear speaker impedance 16 ohm + * Note the first max value below must be less then the min. speaker impedance, + * to allow CTIA/OMTP detection to work. The other max values are the closest + * value from extcon-arizona.c:arizona_micd_levels halfway 2 button resistances. + */ +static const struct arizona_micd_range arizona_micd_aosp_ranges[] = { + { .max = 11, .key = KEY_PLAYPAUSE }, + { .max = 186, .key = KEY_VOICECOMMAND }, + { .max = 348, .key = KEY_VOLUMEUP }, + { .max = 752, .key = KEY_VOLUMEDOWN }, +}; + +static void arizona_spi_acpi_remove_lookup(void *lookup) +{ + gpiod_remove_lookup_table(lookup); +} + +static int arizona_spi_acpi_probe(struct arizona *arizona) +{ + struct gpiod_lookup_table *lookup; + int i, ret; + + /* Add mappings for the 2 ACPI declared GPIOs used for reset and ldo-ena */ + devm_acpi_dev_add_driver_gpios(arizona->dev, arizona_acpi_gpios); + + /* Add lookups for the SoCs own GPIOs used for micdet-polarity and spkVDD-enable */ + lookup = devm_kzalloc(arizona->dev, + struct_size(lookup, table, ARRAY_SIZE(arizona_soc_gpios) + 1), + GFP_KERNEL); + if (!lookup) + return -ENOMEM; + + lookup->dev_id = dev_name(arizona->dev); + for (i = 0; i < ARRAY_SIZE(arizona_soc_gpios); i++) + lookup->table[i] = arizona_soc_gpios[i]; + + gpiod_add_lookup_table(lookup); + ret = devm_add_action_or_reset(arizona->dev, arizona_spi_acpi_remove_lookup, lookup); + if (ret) + return ret; + + /* Enable 32KHz clock from SoC to codec for jack-detect */ + acpi_evaluate_object(ACPI_HANDLE(arizona->dev), "CLKE", NULL, NULL); + + /* + * Some DSDTs wrongly declare the IRQ trigger-type as IRQF_TRIGGER_FALLING + * The IRQ line will stay low when a new IRQ event happens between reading + * the IRQ status flags and acknowledging them. When the IRQ line stays + * low like this the IRQ will never trigger again when its type is set + * to IRQF_TRIGGER_FALLING. Correct the IRQ trigger-type to fix this. + */ + arizona->pdata.irq_flags = IRQF_TRIGGER_LOW; + + /* Wait 200 ms after jack insertion */ + arizona->pdata.micd_detect_debounce = 200; + + /* Use standard AOSP values for headset-button mappings */ + arizona->pdata.micd_ranges = arizona_micd_aosp_ranges; + arizona->pdata.num_micd_ranges = ARRAY_SIZE(arizona_micd_aosp_ranges); + + return 0; +} + +static const struct acpi_device_id arizona_acpi_match[] = { + { + .id = "WM510204", + .driver_data = WM5102, + }, + { + .id = "WM510205", + .driver_data = WM5102, + }, + { }, +}; +MODULE_DEVICE_TABLE(acpi, arizona_acpi_match); +#else +static void arizona_spi_acpi_probe(struct arizona *arizona) +{ +} +#endif + static int arizona_spi_probe(struct spi_device *spi) { const struct spi_device_id *id = spi_get_device_id(spi); @@ -30,6 +141,8 @@ static int arizona_spi_probe(struct spi_device *spi) if (spi->dev.of_node) type = arizona_of_get_type(&spi->dev); + else if (ACPI_COMPANION(&spi->dev)) + type = (unsigned long)acpi_device_get_match_data(&spi->dev); else type = id->driver_data; @@ -75,6 +188,12 @@ static int arizona_spi_probe(struct spi_device *spi) arizona->dev = &spi->dev; arizona->irq = spi->irq; + if (ACPI_COMPANION(&spi->dev)) { + ret = arizona_spi_acpi_probe(arizona); + if (ret) + return ret; + } + return arizona_dev_init(arizona); } @@ -102,6 +221,7 @@ static struct spi_driver arizona_spi_driver = { .name = "arizona", .pm = &arizona_pm_ops, .of_match_table = of_match_ptr(arizona_of_match), + .acpi_match_table = ACPI_PTR(arizona_acpi_match), }, .probe = arizona_spi_probe, .remove = arizona_spi_remove, -- 2.28.0
