alsa-project/alsa-utils issue #55 was edited from maxmbed: ### Description I am encountering an unexpected behaviour with pulse audio master volume in my application. If I set for example left channel to 100% and right channel 0%, and play mono audio file (i.e. audio file with 1 channel only), then I would expect to hear only the audio file on left channel. The actual behaviour in the example of above is when playing the audio file, the Master volume right channel will be automatically adjusted to 50%. If play again it increases to 75% and so on. This issue happens also with other R/L volume level, the case of above is just an example. **Important to note the case does not happen with stereo audio file** where audio sounds on left only channel without altering the volume level of right channel as we can expect. ### Steps to repeat issue: (a) Set mixer Lch to 100%, Rch to 0% ``` $ amixer -D default sset Master 65535,0 Simple mixer control 'Master',0 Capabilities: pvolume pswitch pswitch-joined Playback channels: Front Left - Front Right Limits: Playback 0 - 65536 Mono: Front Left: Playback 65535 [100%] [on] Front Right: Playback 0 [0%] [on] ``` (b) Play mono audio file ``` $ aplay -D default ringtone.wav Playing WAVE 'ringtone.wav' : Signed 16 bit Little Endian, Rate 44100 Hz, Mono ``` ### Request (1) Is it by design expected ? (2) Is there a way to prevent this phenomenon (command option) ? Issue URL : https://github.com/alsa-project/alsa-utils/issues/55 Repository URL: https://github.com/alsa-project/alsa-utils