Hi, I have been getting "pop" sounds from the speaker on my rk3399-gru-kevin for a while, and bisected it to 128f825aeab7 ("ASoC: max98357a: move control of SD_MODE to DAPM"), but looks like the pops were somewhat expected: On 12 Feb 2020 13:55:15 +0800, Tzung-Bi Shih wrote [1]: > Possible drawback: may generate pop noise when BCLK=on but LRCLK=off. > As the datasheet[2] mentioned: > > Do not remove LRCLK while BCLK is present. > > Removing LRCLK while BCLK is present can cause unexpected output behavior > > including a large DC output voltage. [1] https://lore.kernel.org/alsa-devel/20200212055517.122728-1-tzungbi@xxxxxxxxxx/ As of v5.8-rc5 I'm still getting the speaker pops. More info below, but not all pops coincide with "set sdmode" messages, and vice versa. Reverting that commit stops the pops, but then the "Speakers Switch" can no longer mute the speakers. I don't really know much about these things, could anyone have a look at it? I'll try to read relevant documentation and code to make sense of it, but wanted to send an email in case there is an immediately obvious solution (besides reverting) and maybe just nobody had the time to implement it yet. Thanks in advance. --- I've experimented a bit on a Debian userspace (with #define DEBUG 1 to get sdmode messages), here's what happens without PulseAudio: - When playback starts, speaker pops with "set sdmode to 1". - During playback, toggling "Speakers Switch" sets sdmode to 0/1 and mutes/unmutes speakers without any pops. - Pausing/resuming playback (like seeking on a media player) make pops without changing sdmode. Also pops when playback ends (e.g. when "speaker-test -l 1" quits). - A few seconds after playback ends, speaker pops for the last time with "set sdmode to 0". - Within that few seconds, toggling "Speakers Switch" sets sdmode to 0/1 and makes a pop each time. It's mostly the same with PulseAudio but: - Pause/resume during playback doesn't make any pops. - The penultimate pop happens a few seconds after playback stops, when PA says it's suspending the max98357a device (no sdmode changes). - The final pop comes a few seconds after that (still with "set sdmode to 0"). Even without any playback it makes several pops during boot when e.g. PulseAudio starts/stops running in the display manager or in the user session.