On Fri, Feb 21, 2020 at 10:41 AM Jaroslav Kysela <perex@xxxxxxxx> wrote:
> Dne 21. 02. 20 v 15:44 Kai Vehmanen napsal(a):
> > Hi,
> >
> > +Ranjani who did the link reorder patch
> >
> > On Fri, 21 Feb 2020, Jaroslav Kysela wrote:
> >
> >> This patch is for SOF v1.3 firmware. The DSP firmware will crash (DSP
> oops)
> >> without this patch. The 1.4.1 firmare has this issue fixed.
> >>
> >> The ABI version is used for the comparison, because the firmware version
> >> for the firmware files before 1.4.2 was not set properly (git hash was
> >> used).
> >
> > build fails when this is applied on broonie/for-next. You need an
> > additional
> >
> > --- a/sound/soc/sof/topology.c
> > +++ b/sound/soc/sof/topology.c
> > @@ -3108,6 +3108,7 @@ static int sof_link_load(struct snd_soc_component
> > *scomp, int index,
> > struct snd_soc_dai_link *link,
> > struct snd_soc_tplg_link_config *cfg)
> > {
> > + struct snd_sof_dev *sdev = snd_soc_component_get_drvdata(scomp);
> > struct snd_soc_tplg_private *private = &cfg->priv;
> >
> >
> >> - /* set trigger order */
> >> - link->trigger[0] = SND_SOC_DPCM_TRIGGER_POST;
> >> - link->trigger[1] = SND_SOC_DPCM_TRIGGER_POST;
> >> + /* this causes DSP panic on firmware v1.3 */
> >> + if (v->abi_version > SOF_ABI_VER(3, 7, 0)) {
> >> + /* set trigger order */
> >> + link->trigger[0] = SND_SOC_DPCM_TRIGGER_POST;
> >> + link->trigger[1] = SND_SOC_DPCM_TRIGGER_POST;
> >
> > My results with older firmwares and this patch are a bit mixed. When I
> > apply this patch and boot with v1.3 FW on a CFL platform (ABI 3.7.0,
> > version 1:1:0-5dd9a), I get a DSP panic at stream stop with this patch,
> > but _without_ it, playback is fine. :P
> >
> > I tested both v1.3.1 and v1.3, and I get a DSP panic at stream stop with
> > your patch (ABI 3:7:0 on both of these so trigger order is not changed).
> > With v1.4 and all newer, streaming works as expected.
>
> Ok, then I wonder how the pre-5.5 kernel worked (because it's just revert
> of
> 5eee2b3f60065a2530d13f28e771be48b989eb4c for older firmware versions which
> should be tested with the old code).
>
Hi Jaorslav/Kai,
The patch that switch the trigger order in SOF was preceded by another one
which mirrored the actions in the trigger callback based on the trigger
order.
My guess would be that to avoid the DSP panic for the 1.3 FW, you'll likely
need to revert the below as well.
acbf27746ecfa96b290b54cc7f05273482ea128a
ASoC: pcm: update FE/BE trigger order based on the command
Thanks,
Ranjani
