On 2020-02-06 11:46 am, Mark Brown wrote:
On Thu, Feb 06, 2020 at 01:07:12AM +0000, Robin Murphy wrote:
The RK3328 reference design uses an external line driver IC as a buffer
on the analog codec output, enabled by the GPIO_MUTE pin, and such a
configuration is currently assumed in the codec driver's direct poking
of GRF_SOC_CON10 to control the GPIO_MUTE output value. However, some
This makes sense but it is an ABI break so is going to need
quirking for existing boards that unfortunately rely on the
existing behaviour.
Yeah, that's where it gets tricky - there doesn't seem to be a nice way
to differentiate between "no GPIO because old DT" and "no GPIO because
the enable is hard-wired/irrelevant and GPIO_MUTE doesn't do what you
think it does", and it seems really improper to introduce a DT property
for the sole purpose of telling a Linux driver not to assume something
it shouldn't really have in the first place.
My opinion fell on the side of a minor ABI break being the lesser of two
evils, given that the worst case once people start enabling this codec
on Renegade/ROC-CC boards (which I was only anticipating, but have just
discovered is happening already[1]) results in unexpectedly stuffing
3.3V into the SD card and SoC I/O domain while both are in 1.8V mode,
and that the change would only really affect one other current board
(Rock64), where most mainline users are likely to be upgrading their DTB
in lock-step with the kernel anyway.
I guess the existing (mis)behaviour could be predicated on an
of_machine_is_compatible() check for Rock64 boards - it's ugly, but
should do the job if you feel it's more important to be 100% strict
about not regressing supported systems for any possible kernel/DTB
combination.
Thanks,
Robin.
[1]
https://github.com/armbian/build/commit/18b24717be9639b65b86db3dbcf2b42fe73ca12c
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
