On Tue, 21 Jan 2020 09:17:34 +0100, Tobias wrote: > > Thanks a lot for the hint Alexander. Anyhow, I am not sure where to > put that. > Also Takashi Iwai was involved already and I would like to prevent > mixing up things or double work. Just go testing as Alexander suggested. I'm too busy for other tasks and have little time to investigate your devices right now, in anyway... thanks, Takashi > Please advise in detail what I would need to do as I am not a programmer. > > Thanks a lot. > Tobias > > Am 20.01.20 um 09:22 schrieb Alexander Tsoy: > > В Сб, 14/12/2019 в 09:24 +0100, Tobias пишет: > >> Hello dear ALSA developers. > >> > >> I have purchased a MC7000 controller in order to control MIXXX on > >> Ubuntu > >> 16.04. According to the Denon specification the controller should > >> have > >> been class compliant but there is an issue with the Audio interface > >> to > >> work properly giving following message ... > >> > >> $ dmesg > >> ... > >>> [ 74.522831] usb 1-1.3: new high-speed USB device number 6 using > >>> xhci_hcd > >> [ 74.623784] usb 1-1.3: New USB device found, idVendor=15e4, > >> idProduct=8004 > >> [ 74.623789] usb 1-1.3: New USB device strings: Mfr=1, Product=2, > >> SerialNumber=3 > >> [ 74.623793] usb 1-1.3: Product: DENON DJ MC7000 > >> [ 74.623796] usb 1-1.3: Manufacturer: DENON DJ > >> [ 74.623798] usb 1-1.3: SerialNumber: 201603 > >> [ 74.625134] usb 1-1.3: clock source 65 is not valid, cannot use > >> > >> "|||clock source 65 is not valid, cannot use" is repeated > >> uncountable > >> times then > >> > > Please try to add delay after each class control request in > > snd_usb_ctl_msg_quirk(): > > > > if (chip->usb_id == USB_ID(0x15e4, 0x8004) && > > (requesttype & USB_TYPE_MASK) == USB_TYPE_CLASS) > > msleep(20); > > > _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx https://mailman.alsa-project.org/mailman/listinfo/alsa-devel
