Hi
I managed to get the snd_usb_usx2y driver running on an Linksys NSLU2.
The whole stuff is running under debian etch.
Kernel Version is 2.6.18 with Debian patches. Below is a little patch
to be able to enable the driver. Unfortunatly the driver gives the error:
Sequence Error!(hcd_frame=7 ep=8in;wait=65539,frame=3).
Most propably some urb of usb-frame 65539 is still missing.
Cause could be too long delays in usb-hcd interrupt handling.
Which is the output of the function usX2Y_error_sequence. This function is
only called from usbusx2yaudio.c:328. Since all numbers lie just above 65535
(They are all between 65537 and 65540) is suspect that there is some wrap
around error, especially because the values are anded with a 16 bit mask
(0xffff). But unfortunatly i don't know to much about usb right now. Any
hints to resolve this problem?
The cpu runs with 266Mhz, so it could be that it would be really to slow, but
i really suspect an wrap-around error. Any hints or ideas to solve this
issue?
Thanks
ST
--- a/sound/usb/Kconfig
+++ b/sound/usb/Kconfig
@@ -18,7 +18,7 @@ config SND_USB_AUDIO
config SND_USB_USX2Y
tristate "Tascam US-122, US-224 and US-428 USB driver"
- depends on SND && USB && (X86 || PPC || ALPHA)
+ depends on SND && USB && (X86 || PPC || ALPHA ||ARM)
select SND_HWDEP
select SND_RAWMIDI
select SND_PCM
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
